Related Experiment Video
Updated: Jun 22, 2026
Evaluating the Effects of Different Polishing Methods on Color Stability of Dental Restorations in Pediatric Dentistry
Published on: June 6, 2025
The effect of dentin desensitizer with different layers on thermal changes on the pulp during fabrication of
Aysegul G Gurbulak1, Kerem Kiliç, Mustafa Zortuk
1Department of Prosthodontics, Faculty of Dentistry, Erciyes University, Kayseri, Turkey.
Purpose:
This study investigated the effects of different desensitizers and an adhesive material application on pulpal temperature rise during direct provisional restoration polymerization.
Materials And Methods:
Two dentin desensitizers (Systemp, Ivoclar; BisBlock, Bisco) and a dentin adhesive (Prime Bond, Dentsply) were applied to the dentin surfaces as single layer or double layer. One autopolymerizing methacrylate (Prevision, Heraeus Kulzer) and one light polymerizing composite (Revotek LC, GC) provisional restoration materials were used in this study. A total of 160 dentin disks were prepared from extracted molars. These dentin disks were placed on an apparatus developed to measure temperature rise. After the desensitizer or dentin adhesive application, provisional materials were polymerized according to the manufacturers' instructions. The temperature increase was measured under the dentin disk with a J-type thermocouple wire that was connected to a data logger. Differences between initial and highest temperature reading were taken, and 10 readings were averaged to determine the mean value in temperature rise. Statistical analysis was performed with three-way analysis of variance followed by Tukey HSD test (alpha = 0.05).
Results:
Temperature rise varied according to the provisional restoration material used (composite resin, methacrylate) (p < 0.001), the agent thickness (single, double) (p < 0.001), and the agent (desensitizer, adhesive) (p < 0.001). The composite resin-based provisional material induced higher thermal changes than methacrylate based provisional material (p < 0.01).
Conclusion:
The thickness of desensitizing agents affected the thermal changes; however, the desensitizers did not affect on the intrapulpal temperature although the type of provisional material used may be effective.