Related Experiment Video
Updated: Jun 21, 2026

The Effect of Ultraviolet Radiation on the Chemical Bath Deposition of Bis(thiourea) Cadmium Chloride Crystals and the Subsequent CdS Obtention
Published on: August 30, 2018
Cysteine, thiourea and thiocyanate interactions with clays: FT-IR, Mössbauer and EPR spectroscopy and X-ray
Henrique de Santana1, Andrea Paesano, Antonio C S da Costa
1Departamento de Química-CCE, Universidade Estadual de Londrina, Londrina, PR, 86051-990, Brazil.
Abstract:
The present study examined the adsorption of cysteine, thiourea and thiocyanate on bentonite and montmorillonite at two different pHs (3.00, 8.00). The conditions used here are closer to those of prebiotic earth. As shown by FT-IR, Mössbauer and EPR spectroscopy and X-ray diffractometry, the most important finding of this work is that cysteine and thiourea penetrate into the interlayer of the clays and reduce Fe(3+) to Fe(2+), and as consequence, cystine and c,c'-dithiodiformamidinium ion are formed. This mechanism resembles that which occurs with aconitase. This is a very important result for prebiotic chemistry; we should think about clays not just sink of molecules, but as primitive vessels of production of biomolecules. At pH 8.00, an increasing expansion was observed in the following order for both minerals: thiourea > thiocyanate > cysteine. At pH 3.00, the same order was not observed and thiourea had an opposite behavior, being the compound producing the lowest expansion. Mössbauer spectroscopy showed that at pH 8.00, the proportion of Fe(2+) ions in bentonite increased, doubling for thiourea, or more than doubling for cysteine, in both clays. However, at pH 3.00, cysteine and thiourea did not change significantly the relative amount of Fe(2+) and Fe(3+) ions, when compared to clays without adsorption. For thiocyanate, the amount of Fe(2+) produced was independent of the pH or clay used, probably because the interlayers of clays are very acidic and HSCN formed does not reduce Fe(3+) to Fe(2+). For the interaction of thiocyanate with the clays, it was not possible to identify any potential compound formed. For the samples of bentonite and montmorillonite at pH 8.00 with cysteine, EPR spectroscopy showed that intensity of the lines due to Fe(3+) decreased because the reaction of Fe(3+)/cysteine. Intensity of EPR lines did not change when the samples of bentonite at pH 3.00 with and without cysteine were compared. These results are in accordance with those obtained using Mössbauer and FT-IR spectroscopy.
Related Concept Videos
Crystal Field Theory - Tetrahedral and Square Planar Complexes
Crystal field theory (CFT) is applicable to molecules in geometries other than octahedral. In octahedral complexes, the lobes of the dx2−y2 and dz2 orbitals point directly at the ligands. For tetrahedral complexes, the d orbitals remain in place, but with only four ligands located between the axes. None of the orbitals points directly at the tetrahedral ligands. However, the dx2−y2 and dz2 orbitals (along the Cartesian axes) overlap with the ligands less than the dxy,...
Crystal Field Theory - Octahedral Complexes
To explain the observed behavior of transition metal complexes (such as colors), a model involving electrostatic interactions between the electrons from the ligands and the electrons in the unhybridized d orbitals of the central metal atom has been developed. This electrostatic model is crystal field theory (CFT). It helps to understand, interpret, and predict the colors, magnetic behavior, and some structures of coordination compounds of transition metals.
CFT focuses on...
Preparation and Reactions of Thiols

