The standard partial molar volumes of ions in solution. Part 4. Ionic volumes in water at 0-100 degrees C

Yizhak Marcus1

  • 1Institute of Chemistry, The Hebrew University of Jerusalem, Jerusalem 91904, Israel. ymarcus@vms.huji.ac.il

Related Concept Videos

Solubility Equilibria: Ionic Product of Water01:16

Solubility Equilibria: Ionic Product of Water

Pure water is a weak electrolyte; only a small amount ionizes into hydrogen and hydroxide ions. At any given temperature, the concentration of undissociated water is almost constant, so the ionic product of water is the product of the hydrogen and hydroxide ion concentrations, denoted as Kw. The square root of Kw gives the individual ion concentrations.
The ionic product of water varies with temperature, and its value is 1.0 x 10−14 at standard experimental conditions. Per Le Chatelier's...
Electrolytes: van't Hoff Factor03:08

Electrolytes: van't Hoff Factor

Colligative Properties of ElectrolytesThe colligative properties of a solution depend only on the number, not on the identity, of solute species dissolved. The concentration terms in the equations for various colligative properties (freezing point depression, boiling point elevation, osmotic pressure) pertain to all solute species present in the solution. Nonelectrolytes dissolve physically without dissociation or any other accompanying process. Each molecule that dissolves yields one dissolved...
Ionic Strength: Overview01:12

Ionic Strength: Overview

The ionic strength of a solution is a quantitative way of expressing the total electrolyte concentration of a solution. This concept was first introduced in 1921 by two American physical chemists, Gilbert N. Lewis and Merle Randall, while describing the activity coefficient of strong electrolytes. During the calculation of ionic strength (I or μ), all the cations and anions are considered. However, the concentration (c) of an ion with a greater charge number (z) has a greater contribution to...
Water: A Bronsted-Lowry Acid and Base02:30

Water: A Bronsted-Lowry Acid and Base

The reaction between a Brønsted-Lowry acid and water is called acid ionization. For example, when hydrogen fluoride dissolves in water and ionizes, protons are transferred from hydrogen fluoride molecules to water molecules, yielding hydronium ions and fluoride ions:
Solubility of Ionic Compounds02:55

Solubility of Ionic Compounds

Solubility is the measure of the maximum amount of solute that can be dissolved in a given quantity of solvent at a given temperature and pressure. Solubility is usually measured in molarity (M) or moles per liter (mol/L). A compound is termed soluble if it dissolves in water.
Expressing Solution Concentration02:48

Expressing Solution Concentration

A solute is a component of a solution that is typically present at a much lower concentration than the solvent. Solute concentrations are often described with qualitative terms such as dilute (of relatively low concentration) and concentrated (of relatively high concentration).
Concentrations may be quantitatively assessed using a wide variety of measurement units, each convenient for particular applications. Molarity (M) is a useful concentration unit for many applications in chemistry.