External radiation assessment in a wet phosphoric acid production plant

The factories dedicated to the production of phosphoric acid by the so-called wet acid method are usually considered typical NORM industries, because the phosphate rock used as raw material usually contains high concentrations of (238)U-series radionuclides. The magnitude and behaviour of the radionuclides involved in the production process revealed the need to determine its dosimetric impact on workers. This work aims to partially compensate this lack of knowledge through the determination of external effective dose rates at different zones in the process at a typical plant located in the southwest of Spain. To this end, two dosimetric sampling campaigns have been carried out at this phosphoric acid production plant. The first sampling was carried out when phosphate rocks originating in Morocco were processed, and the second one when phosphate rock processed came from the Kola Peninsula (Russia Federation). This differentiation was necessary because the activity concentrations are almost one order of magnitude higher in Moroccan phosphate rock than in Kola phosphate rock. The results obtained have reflected external dose rate enhancements as high as 1.4microSvh(-1) (i.e., up to thirty times the external exposition due to radionuclides in unperturbed soils) at several points in the facility, particularly where the digested rock (pulp) is filtered. However, the most problematic points are characterised by a small occupation factor. That means that the increment in the annual effective external gamma dose received by the most-exposed worker is clearly below 1mSv (European Commission limit for the general population) under normal production. Nevertheless, special care in the design and schedule of cleaning and maintaining work in the areas with high doses should be taken in order to avoid any possibility of exceeding the previously mentioned general population limit. In addition, the results of the dosimetric campaign showed no clear correlation between (226,228)Ra activity concentrations in the material fluxing during the process (the most important radionuclides from the dosimetric point of view) and the external dose rates. Furthermore, any general dependence of the origin of the rock (i.e., on their radioactive contents) on the external effective dose rate measured has not been observed. These latter findings could be a consequence of three effects: (1) a variable radiation shielding at the different points along the process, (2) a changing geometry of irradiation (from a rock pile up to a thin-layered pulp passing through a solid mass inside pipes and deposits), and (3) the existence of a "memory effect", or background contamination in the installation equipment due to the presence of radionuclide-enriched scales and sludges in pipes and deposits.