Related Experiment Video

Updated: Jun 21, 2026

One-pot Microwave-assisted Conversion of Anomeric Nitrate-esters to Trichloroacetimidates
06:00

One-pot Microwave-assisted Conversion of Anomeric Nitrate-esters to Trichloroacetimidates

Published on: January 15, 2018

High-pressure far- and mid-infrared study of 1,3,5-triamino-2,4,6-trinitrobenzene

Michael Pravica1, Brian Yulga, Sergey Tkachev

  • 1High Pressure Science and Engineering Center and Department of Physics, University of Nevada Las Vegas, Las Vegas, Nevada 89154-4002, USA. pravica@physics.unlv.edu

The Journal of Physical Chemistry. A
|July 18, 2009
PubMed

More Related Videos

Preparation of 6-aminocyclohepta-2,4-dien-1-one Derivatives via Tricarbonyl(tropone)iron07:56

Preparation of 6-aminocyclohepta-2,4-dien-1-one Derivatives via Tricarbonyl(tropone)iron

Published on: August 12, 2019

High-Pressure NMR Experiments for Detecting Protein Low-Lying Conformational States04:37

High-Pressure NMR Experiments for Detecting Protein Low-Lying Conformational States

Published on: June 29, 2021

Related Concept Videos

NMR Spectroscopy of Benzene Derivatives01:37

NMR Spectroscopy of Benzene Derivatives

Simple unsubstituted benzene has six aromatic protons, all chemically equivalent. Therefore, benzene exhibits only a singlet peak at δ 7.3 ppm in the 1H NMR spectrum. The observed shift is far downfield because the aromatic ring current strongly deshields the protons. Any substitution on the benzene ring makes the aromatic protons nonequivalent, and the protons split each other. The peak is, therefore, no longer a singlet and the splitting pattern and their associated coupling constants depend...
¹H NMR: Complex Splitting01:13

¹H NMR: Complex Splitting

A proton M that is coupled to a proton X results in doublet signals for M. However, NMR-active nuclei can be simultaneously coupled to more than one nonequivalent nucleus. When M is coupled to a second proton A, such as in styrene oxide, each peak in the doublet is split into another doublet.
Splitting diagrams or splitting tree diagrams are routinely used to depict such complex couplings. While drawing splitting diagrams, the splitting with the larger coupling constant is usually applied first.
¹H NMR of Conformationally Flexible Molecules: Variable-Temperature NMR01:15

¹H NMR of Conformationally Flexible Molecules: Variable-Temperature NMR

The axial and equatorial protons in cyclohexane can be distinguished by performing a variable-temperature NMR experiment. In this process, except for one proton, the remaining eleven protons are replaced by deuterium. The deuterium substitution avoids the possible peak splitting caused by the spin-spin coupling between the adjacent protons. The remaining proton flips between the axial and equatorial positions.
¹H NMR Signal Integration: Overview00:58

¹H NMR Signal Integration: Overview

The intensity of a signal, which can be represented by the area under the peak, depends on the number of protons contributing to that signal. The area under each peak is shown as a vertical line called an integral, with the integral value listed under it, as seen in the proton NMR spectrum of benzyl acetate. Each integral value is divided by the smallest integral value to obtain the ratio of the number of protons producing each signal. The ratio reveals the relative number of protons and not...
¹H NMR of Conformationally Flexible Molecules: Temporal Resolution00:52

¹H NMR of Conformationally Flexible Molecules: Temporal Resolution

At room temperature, the chair conformer of cyclohexane undergoes rapid ring flipping between two equivalent chair conformers at a rate of approximately 105 times per second. These two chair conformers are in equilibrium. The rapid ring flipping results in the interconversion of the axial proton to an equatorial proton and an equatorial to the axial proton. Such interconversions are too rapid and cannot be detected on the NMR timescale. Hence, the NMR spectrometer cannot distinguish between the...
Electrophilic Aromatic Substitution: Nitration of Benzene01:20

Electrophilic Aromatic Substitution: Nitration of Benzene

The nitration of benzene is an example of an electrophilic aromatic substitution reaction. It involves the formation of a very powerful electrophile, the nitronium ion, which is linear in shape. The reaction occurs through the interaction of two strong acids, sulfuric and nitric acid.