Search research articles

ABOUT JoVE

Overview Leadership Blog JoVE Help Center

AUTHORS

Publishing Process Editorial Board Scope & Policies Peer Review FAQ Submit

LIBRARIANS

Testimonials Subscriptions Access Resources Library Advisory Board FAQ

RESEARCH

JoVE Journal Methods Collections JoVE Encyclopedia of Experiments Archive

EDUCATION

JoVE Core JoVE Business JoVE Science Education JoVE Lab Manual Faculty Resource Center Faculty Site

Terms & Conditions of Use

Related Concept Videos

Atomic Emission Spectroscopy: Lab

Atomic Emission Spectroscopy: Lab

AES is a powerful analytical technique, especially effective when used with plasma sources, producing abundant spectra in characteristic emission lines. The Inductively Coupled Plasma (ICP), in particular, yields superior quantitative analytical data due to its high stability, low noise, low background, and minimal interferences under optimal experimental conditions. However, newer air-operated microwave sources are emerging as promising alternatives that could be more cost-effective than...

Inductively Coupled Plasma Atomic Emission Spectroscopy: Principle

Inductively Coupled Plasma Atomic Emission Spectroscopy: Principle

Inductively coupled plasma (ICP) is the most widely used plasma source in atomic emission spectroscopy (AES), also known as Inductively Coupled Plasma Optical Emission Spectroscopy (ICP-OES). The ICP source, or torch, consists of three concentric quartz tubes with argon gas flowing through them. A spark from a Tesla coil initiates the ionization of argon, generating a high-temperature plasma.
The ions and electrons produced interact with the fluctuating magnetic field created by a water-cooled...

Atomic Emission Spectroscopy: Interference

Atomic Emission Spectroscopy: Interference

In atomic emission spectroscopy (AES), high-temperature atomizers excite a broad range of elements and molecules that generate complex emissions from sources such as oxides, hydroxides, and flame combustion products in the flame or plasma. Several strategies can be employed to minimize spectral interferences caused by overlapping emission lines or bands. These include increasing instrument resolution, choosing alternative emission lines, optimally placing the detector in low-background regions,...

You might also read

Related Articles

Articles linked to this work by shared authors, journal, and citation graph.

Sort by

Same author

Direct measurement of the accuracy of CO(2)laser alignment on target.

Applied optics·2010

Same author

Measurement of alignment accuracy for laser fusion experiments.

Applied optics·2010

Same author

Sub-keV x-ray imaging using a low-cost ellipsoidal lens.

Applied optics·2010

Same author

X-ray calibration of RAR 2490 film for application to laser plasma experiments.

Applied optics·2010

Same author

Scaling evolution in shock-induced transition to turbulence.

Physical review. E, Statistical, nonlinear, and soft matter physics·2004

Same journal

Gaussian-modulated continuous-variable quantum key distribution over 60 km fiber using an integrated silicon photonic receiver.

Optics letters·2026

Same journal

E2E-OCT: end-to-end joint learning model using optical coherence tomography images for vocal cord leukoplakia diagnosis.

Optics letters·2026

Same journal

Holographic generation of panoramic 3D scenes by concave ellipsoidal mirror reflection.

Optics letters·2026

Same journal

Dual-pilot phase recovery with pair-wise maximum-ratio combining for coherent PONs.

Optics letters·2026

Same journal

Mapping the whispering gallery modes of a CaF<sub>2</sub> disk resonator with half-tapered fibers to estimate the fundamental mode volume.

Optics letters·2026

Same journal

Quantitative estimation of deep-subwavelength scale via dark-field scattering axial energy concentration decay profiles.

Optics letters·2026

See all related articles

Search research articles

Related Experiment Video

Updated: Jun 21, 2026

Investigation of Early Plasma Evolution Induced by Ultrashort Laser Pulses

Investigation of Early Plasma Evolution Induced by Ultrashort Laser Pulses

Published on: July 2, 2012

X-ray shadowgraphing in laser-produced plasma experiments.

D B VanHulsteyn¹, R F Benjamin

¹Los Alamos Scientific Laboratory, University of California, Los Alamos, New Mexico 87545, USA.

|August 15, 2009

Summary

This summary is machine-generated.

A new x-ray framing camera design achieves 5-microm spatial resolution. This high-resolution imaging was demonstrated using a laser-generated x-ray source with minimal laser energy.

More Related Videos

Applying X-ray Imaging Crystal Spectroscopy for Use as a High Temperature Plasma Diagnostic

Applying X-ray Imaging Crystal Spectroscopy for Use as a High Temperature Plasma Diagnostic

Published on: August 25, 2016

Non-equilibrium Microwave Plasma for Efficient High Temperature Chemistry

Non-equilibrium Microwave Plasma for Efficient High Temperature Chemistry

Published on: August 1, 2017

Related Experiment Videos

Last Updated: Jun 21, 2026

Investigation of Early Plasma Evolution Induced by Ultrashort Laser Pulses

Investigation of Early Plasma Evolution Induced by Ultrashort Laser Pulses

Published on: July 2, 2012

Applying X-ray Imaging Crystal Spectroscopy for Use as a High Temperature Plasma Diagnostic

Applying X-ray Imaging Crystal Spectroscopy for Use as a High Temperature Plasma Diagnostic

Published on: August 25, 2016

Non-equilibrium Microwave Plasma for Efficient High Temperature Chemistry

Non-equilibrium Microwave Plasma for Efficient High Temperature Chemistry

Published on: August 1, 2017

Area of Science:

High-resolution imaging
X-ray optics
Laser-driven plasma physics

Background:

Traditional X-ray imaging methods face limitations in temporal and spatial resolution.
Advancements in laser technology enable new X-ray generation techniques.

Purpose of the Study:

To present a novel design for an X-ray framing camera.
To evaluate the camera's performance in capturing dynamic X-ray events.

Main Methods:

Design and construction of a new X-ray framing camera.
Utilization of a laser-generated X-ray source for shadowgraphing experiments.
Characterization of spatial resolution and energy requirements.

Main Results:

Demonstration of 5-microm spatial resolution capability.
Achieved high resolution with less than 7 Joules of laser energy.
Successful shadowgraphing of experimental targets.

Conclusions:

The designed X-ray framing camera offers a promising solution for high-resolution, low-energy X-ray imaging.
This technology has potential applications in various fields requiring dynamic X-ray diagnostics.