Related Experiment Video
Updated: Jun 20, 2026

Label-free Isolation and Enrichment of Cells Through Contactless Dielectrophoresis
Published on: September 3, 2013
Tipping the balance of deterministic lateral displacement devices using dielectrophoresis
Jason P Beech1, Peter Jönsson, Jonas O Tegenfeldt
1Division of Solid State Physics, Lund, Sweden. jason.beech@ftf.lth.se
Abstract:
We report the use of dielectrophoresis (DEP) to achieve tunability, improve dynamic range and open up for the separation of particles with regard to parameters other than hydrodynamic size in deterministic lateral displacement (DLD) devices. DLD devices have been shown capable of rapidly and continuously separating micrometer sized plastic spheres by size with a resolution of 20 nm in diameter and of being able to handle the separation of biological samples as wide ranging as bacterial artificial chromosomes and blood cells. DEP, while not exhibiting the same resolution in size separation as DLD, has the benefit of being easy to tune and can, by choosing the frequency, be used to probe a variety of particle properties. By combining DLD and DEP we open up for the advantages, while avoiding the drawbacks, of the two techniques. We present a proof of principle in which the critical size for separation of polystyrene beads is tuned in the range 2-6 microm in a single device by the application of moderate (100 V cm(-1)), low frequency (100 Hz) AC electric fields. The behaviour of the device was further investigated by performing simulations of particle trajectories, the results of which were in good qualitative agreement with experiments, indicating the potential of the method for tunable, high-resolution separations with respect to both size and polarisability.
Related Concept Videos
Induced Electric Dipoles
Since the absolute value of potential energy holds no physical meaning, its zero value can be chosen as per...
Magnetic Damping
If, however, the bob is a slotted metal plate, the magnet produces a much smaller effect. When a slotted metal plate enters the field, an emf is induced by the change in flux; however, it is less effective because the slots limit the...
Electrostatic Boundary Conditions in Dielectrics
Consider a case where both the mediums across a boundary are two different dielectric materials. Recall that the electric field and electric displacement are proportional and related through the material's permittivity.
Electrochemical Systems
The Electrical Double Layer
Potential Due to a Polarized Object

