Related Experiment Video
Updated: Jun 20, 2026
Measuring Maxillary Posterior Tooth Movement: A Model Assessment using Palatal and Dental Superimposition
Published on: February 23, 2024
Anteroposterior and vertical components of class II division 1 and division 2 malocclusion
Emad A A Al-Khateeb1, Susan N Al-Khateeb
1Department of Orthodontics, Faculty of Dentistry, Jordan University of Science and Technology, Irbid, Jordan.
Objective:
To describe and analyze the skeletal and dental characteristics associated with Class II division 1 (Class II/1) and Class II division 2 (Class II/2) malocclusions in the anteroposterior and vertical dimensions.
Materials And Methods:
A total of 551 lateral cephalograms were used; 293 films of Class II/1 and 258 films of Class II/2 malocclusions. Lateral cephalographs were traced and analyzed. Parameters for both malocclusions were compared with each other and with the norms calculated for the Jordanian population in another study.
Results:
The maxilla was prognathic in both malocclusions. The mandible was retrognathic in Class II/1 and orthognathic in Class II/2. Vertically, LAFH was significantly reduced in patients with Class II/2 compared with subjects with Class II/1 who exhibited a significantly increased LAFH. In Class II/1, the lower incisors were proclined and the interincisal angle was reduced, while in Class II/2 the lower incisors were at a normal inclination and the interincisal angle was significantly increased.
Conclusions:
Class II/2 may be considered as a separate entity which differs in almost all skeletal and dental features from Class I and Class II/1. A Class II skeletal pattern and reduced interincisal angle were common features of Class II/1 malocclusion, while a Class II skeletal pattern, increased interincisal angle, and skeletal deep bite were common features of Class II/2 malocclusion.
Related Concept Videos
01:09Functional Classification of Joints
The functional classification of joints is determined by the amount of mobility between the adjacent bones. Joints are functionally classified as a synarthrosis or immobile joint, an amphiarthrosis or slightly moveable joint, or as a diarthrosis, a freely moveable joint. Fibrous and cartilaginous joints can be functionally classified as either synarthroses or amphiarthroses, whereas all synovial joints are classified as diarthroses.
Synarthrosis
An immobile...
01:14Cranial Bones: Superior and Posterior View
The frontal bone is the single bone that forms the forehead. At its anterior midline, between the eyebrows, there is a slight depression called the glabella. The frontal bone also forms the supraorbital margin of the orbit. Near the middle of this margin is the supraorbital foramen, the opening that provides passage for a sensory nerve to the forehead. The frontal bone is thickened just above each supraorbital margin,...
01:27Cranial Bones: Lateral View
The temporal bone forms the lower lateral side of the skull. The temporal bone is subdivided into several regions. The flattened upper portion is the squamous portion of the temporal bone. Below this area and projecting anteriorly is the zygomatic process of the temporal bone, which forms the posterior portion of the zygomatic arch. Posteriorly is the mastoid portion of the temporal bone. Projecting...
01:21Tooth Anatomy
The Crown, Neck, and Root
The visible part of the tooth is referred to as the crown. It's covered by enamel, the hardest substance in the human body. The crown is uniquely shaped for each type of tooth, allowing for different functions such as cutting, tearing, or grinding food.
01:06Body Planes
The sagittal plane is the plane that divides the body or an organ vertically into right and left sides. If this vertical plane runs directly down the middle of the body resulting in equal division, it is called the midsagittal or median...
01:20Structural Classification of Joints
A fibrous joint is where the adjacent bones are united by fibrous connective...