Related Experiment Video

Updated: Jun 20, 2026

Infrared Degenerate Four-wave Mixing with Upconversion Detection for Quantitative Gas Sensing
10:42

Infrared Degenerate Four-wave Mixing with Upconversion Detection for Quantitative Gas Sensing

Published on: March 22, 2019

Narrowed intermediate resonance in multiresonant four-wave mixing in LiTbF(4)

D A Ender, M S Otteson, R L Cone

    Optics Letters
    |August 29, 2009
    PubMed

    More Related Videos

    Measurement of Coherence Decay in GaMnAs Using Femtosecond Four-wave Mixing15:58

    Measurement of Coherence Decay in GaMnAs Using Femtosecond Four-wave Mixing

    Published on: December 3, 2013

    High Resolution Phonon-assisted Quasi-resonance Fluorescence Spectroscopy10:40

    High Resolution Phonon-assisted Quasi-resonance Fluorescence Spectroscopy

    Published on: June 28, 2016

    Related Concept Videos

    Double Resonance Techniques: Overview01:12

    Double Resonance Techniques: Overview

    Double resonance techniques in Nuclear Magnetic Resonance (NMR) spectroscopy involve the simultaneous application of two different frequencies or radiofrequency pulses to manipulate and observe two distinct nuclear spins. One important application of double resonance is spin decoupling, which selectively suppresses coupling with one type of nucleus while observing the NMR signal from another nucleus, simplifying the spectrum and enhancing resolution.
    Spin decoupling is usually achieved by...
    Parallel Resonance01:23

    Parallel Resonance

    The parallel RLC circuit is an arrangement where the resistor (R), inductor (L), and capacitor (C) are all connected to the same nodes and, as a result, share the same voltage across them. The parallel RLC circuit is analyzed in terms of admittance (Y), which reflects the ease with which current can flow. The admittance is given by:
    Resonance in an AC Circuit01:26

    Resonance in an AC Circuit

    The property of an inductor makes it resist any change in the current passing through it, while the property of a capacitor is to build up the charge across its terminals. Hence, if an inductor and capacitor are connected in series, they have opposite effects on the relative phase between current and voltage. The current through the circuit undergoes forced oscillation at the frequency of the source. The resistance term in an R-L-C circuit acts as a damping term because power is dissipated...
    Sound Waves: Resonance01:14

    Sound Waves: Resonance

    Resonance is produced depending on the boundary conditions imposed on a wave. Resonance can be produced in a string under tension with symmetrical boundary conditions (i.e., has a node at each end). A node is defined as a fixed point where the string does not move. The symmetrical boundary conditions result in some frequencies resonating and producing standing waves, while other frequencies interfere destructively. Sound waves can resonate in a hollow tube, and the frequencies of the sound...
    Resonance and Hybrid Structures02:16

    Resonance and Hybrid Structures

    According to the theory of resonance, if two or more Lewis structures with the same arrangement of atoms can be written for a molecule, ion, or radical, the actual distribution of electrons is an average of that shown by the various Lewis structures.
    Resonance Structures and Resonance Hybrids
    The Lewis structure of a nitrite anion (NO2−) may actually be drawn in two different ways, distinguished by the locations of the N–O and N=O bonds.
    ¹H NMR: Complex Splitting01:13

    ¹H NMR: Complex Splitting

    A proton M that is coupled to a proton X results in doublet signals for M. However, NMR-active nuclei can be simultaneously coupled to more than one nonequivalent nucleus. When M is coupled to a second proton A, such as in styrene oxide, each peak in the doublet is split into another doublet.
    Splitting diagrams or splitting tree diagrams are routinely used to depict such complex couplings. While drawing splitting diagrams, the splitting with the larger coupling constant is usually applied first.