Related Experiment Video
Updated: Jun 20, 2026

12:21
Stimulated Stokes and Antistokes Raman Scattering in Microspherical Whispering Gallery Mode Resonators
Published on: April 4, 2016
Cross talk caused by stimulated Raman scattering in single-mode wavelength-division multiplexed systems
Optics Letters
|September 1, 2009
Abstract:
By using cw laser diodes operating at 1.26 and 1.34 microm, the cross talk caused by stimulated Raman scattering in a 21-km single-mode fiber was measured to be -25.2 dB at a pump-power level of 1.0 mW. The Raman-gain coefficient was calculated to be 0.57 x 10(-11) cm/W, which is in good agreement with previously reported values measured with high-power pulsed lasers.
Related Concept Videos
Raman Spectroscopy: Overview
The underlying principle of Raman spectroscopy is based on the interaction between light and matter, specifically molecules' inelastic scattering of photons. When a monochromatic beam of light, typically from a laser source, interacts with a sample, most scattered light has the same frequency as the incident light. This is known as Rayleigh scattering.
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and the...
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and the...
Raman Spectroscopy Instrumentation: Overview
A conventional Raman spectrophotometer includes a laser source, a sample holding system, a wavelength selector, and a detector.
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...

