Related Experiment Video

Updated: Jun 20, 2026

Ultrasonic-Assisted Preparation of Biodiesel Products from Vegetable Oils
04:40

Ultrasonic-Assisted Preparation of Biodiesel Products from Vegetable Oils

Published on: April 19, 2024

Properties of Tung oil biodiesel and its blends with 0# diesel

Qiong Shang1, Wei Jiang, Houfang Lu

  • 1College of Chemical Engineering, Sichuan University, Chengdu 610065, PR China.

Bioresource Technology
|September 9, 2009
PubMed

More Related Videos

Original Experimental Approach for Assessing Transport Fuel Stability09:48

Original Experimental Approach for Assessing Transport Fuel Stability

Published on: October 21, 2016

Experimental Protocol for Biodiesel Production with Isolation of Alkenones as Coproducts from Commercial Isochrysis Algal Biomass09:10

Experimental Protocol for Biodiesel Production with Isolation of Alkenones as Coproducts from Commercial Isochrysis Algal Biomass

Published on: June 24, 2016

Related Concept Videos

Biofuels01:25

Biofuels

The microbial conversion of organic matter into biofuels holds potential as a renewable energy source. Among biofuel sources, microalgae are recognized as a highly efficient and adaptable feedstock for biodiesel production, owing to their rapid biomass accumulation, elevated lipid productivity, and capacity to proliferate in diverse aquatic systems, including freshwater, marine, and wastewater habitats. Unlike terrestrial crops, microalgae do not compete for land and can achieve significantly...
Oxidation of Alkenes: Syn Dihydroxylation with Potassium Permanganate02:21

Oxidation of Alkenes: Syn Dihydroxylation with Potassium Permanganate

Alkenes can be dihydroxylated using potassium permanganate. The method encompasses the reaction of an alkene with a cold, dilute solution of potassium permanganate under basic conditions to form a cis-diol along with a brown precipitate of manganese dioxide.
Otto and Diesel Cycle01:27

Otto and Diesel Cycle

An Otto engine is a four-stroke engine that uses a mixture of gasoline and air as the working fuel. The fuel is injected into the cylinder, and the piston is moved completely down so that the cylinder is at maximum volume. By moving the piston up, adiabatic compression takes place. The spark plug ignites the gasoline-air mixture, and the burning fuel adds heat to the system at a constant volume. The heated mixture expands adiabatically and gets further cooled by exhausting heat, and this cyclic...