Related Experiment Video
Updated: Jun 20, 2026

12:56
Differential Imaging of Biological Structures with Doubly-resonant Coherent Anti-stokes Raman Scattering (CARS)
Published on: October 17, 2010
Effect of pump-laser linewidth on noise in single-pulse coherent anti-Stokes Raman spectroscopy temperature
Optics Letters
|September 11, 2009
Abstract:
When N(2) is used as the probe molecule in a stable premixed propane-air flame near 2100 K, the standard deviation in single-pulse coherent anti-Stokes Raman spectroscopy (CARS) temperature measurements is shown to decrease by 20% as the pump-laser linewidth increases from =0.02 to about 0.7 cm(-1). This effect is shown to be independent of the signal level at the detector array over the range considered. An instrument function that is useful in CARS convolution calculations is also presented.
Related Concept Videos
Raman Spectroscopy: Overview
The underlying principle of Raman spectroscopy is based on the interaction between light and matter, specifically molecules' inelastic scattering of photons. When a monochromatic beam of light, typically from a laser source, interacts with a sample, most scattered light has the same frequency as the incident light. This is known as Rayleigh scattering.
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and the...
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and the...
Raman Spectroscopy Instrumentation: Overview
A conventional Raman spectrophotometer includes a laser source, a sample holding system, a wavelength selector, and a detector.
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...

