Related Experiment Video

Updated: Jun 20, 2026

Ultrafast Time-resolved Near-IR Stimulated Raman Measurements of Functional π-conjugate Systems
09:57

Ultrafast Time-resolved Near-IR Stimulated Raman Measurements of Functional π-conjugate Systems

Published on: February 10, 2020

Measurement of Raman gain of the S(8) transition of N(2)

D Klimek, K Leung, M Oron

    Optics Letters
    |September 11, 2009
    PubMed

    More Related Videos

    Resonance Raman Spectroscopy of Extreme Nanowires and Other 1D Systems07:44

    Resonance Raman Spectroscopy of Extreme Nanowires and Other 1D Systems

    Published on: April 28, 2016

    Stimulated Stokes and Antistokes Raman Scattering in Microspherical Whispering Gallery Mode Resonators12:21

    Stimulated Stokes and Antistokes Raman Scattering in Microspherical Whispering Gallery Mode Resonators

    Published on: April 4, 2016

    Related Concept Videos

    Raman Spectroscopy Instrumentation: Overview01:26

    Raman Spectroscopy Instrumentation: Overview

    A conventional Raman spectrophotometer includes a laser source, a sample holding system, a wavelength selector, and a detector.
    The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...
    Raman Spectroscopy: Overview01:20

    Raman Spectroscopy: Overview

    The underlying principle of Raman spectroscopy is based on the interaction between light and matter, specifically molecules' inelastic scattering of photons. When a monochromatic beam of light, typically from a laser source, interacts with a sample, most scattered light has the same frequency as the incident light. This is known as Rayleigh scattering.
    However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and the...
    NMR Spectroscopy Of Amines01:19

    NMR Spectroscopy Of Amines

    In proton NMR spectroscopy, primary amines and secondary amines showcase their N–H protons as a broad signal in the chemical shift range between δ 0.5 and 5 ppm. The exact position in this range depends on several factors, including sample concentration, hydrogen bonding, and the type of solvent used. Since amine protons undergo fast proton exchange in solution, the protons are labile and therefore do not participate in any splitting with adjacent protons. Thus, the observed peak is broad and...
    Molecular Spectroscopy: Absorption and Emission01:14

    Molecular Spectroscopy: Absorption and Emission

    Molecules possess discrete energy levels called quantum states. Unlike atoms, which have simpler energy levels, molecules possess additional rotational and vibrational energy levels. Each energy level is separated by an energy gap, with the gaps between adjacent electronic, vibrational, and rotational levels varying significantly. The three types of energy levels in a diatomic molecule are shown in Figure 1.
    IR Spectrum Peak Splitting: Symmetric vs Asymmetric Vibrations01:08

    IR Spectrum Peak Splitting: Symmetric vs Asymmetric Vibrations

    Identical bonds within a polyatomic group can stretch symmetrically (in-phase) or asymmetrically (out-of-phase). Similar to hydrogen bonding, these vibrations also influence the shape of the IR peak. Generally, asymmetric stretching frequencies are higher than symmetric stretching frequencies. For example, primary amines exhibit two distinct IR peaks between 3300–3500 cm−1 corresponding to the symmetric and asymmetric N-H stretching, while secondary amines exhibit a single stretching vibration...
    IR Spectroscopy: Hooke's Law Approximation of Molecular Vibration01:16

    IR Spectroscopy: Hooke's Law Approximation of Molecular Vibration

    A covalently bonded heteronuclear diatomic molecule can be modeled as two vibrating masses connected by a spring. The vibrational frequency of the bond can be expressed using an equation derived from Hooke's law, which describes how the force applied to stretch or compress a spring is proportional to the displacement of the spring. In this case, the atoms behave like masses, and the bond acts like a spring.
    According to Hooke's law, the vibrational frequency is directly proportional to the...