Related Experiment Video

Updated: Jun 20, 2026

Non-equilibrium Microwave Plasma for Efficient High Temperature Chemistry
07:17

Non-equilibrium Microwave Plasma for Efficient High Temperature Chemistry

Published on: August 1, 2017

Saturation of the Xe III 109-nm laser using traveling-wave laser-produced-plasma excitation

M H Sher, J J Macklin, J F Young

    Optics Letters
    |September 11, 2009
    PubMed

    More Related Videos

    Measurement of Ultrafast Vibrational Coherences in Polyatomic Radical Cations with Strong-Field Adiabatic Ionization08:22

    Measurement of Ultrafast Vibrational Coherences in Polyatomic Radical Cations with Strong-Field Adiabatic Ionization

    Published on: August 6, 2018

    Investigation of Early Plasma Evolution Induced by Ultrashort Laser Pulses11:20

    Investigation of Early Plasma Evolution Induced by Ultrashort Laser Pulses

    Published on: July 2, 2012

    Related Concept Videos

    Inductively Coupled Plasma Atomic Emission Spectroscopy: Principle01:19

    Inductively Coupled Plasma Atomic Emission Spectroscopy: Principle

    Inductively coupled plasma (ICP) is the most widely used plasma source in atomic emission spectroscopy (AES), also known as Inductively Coupled Plasma Optical Emission Spectroscopy (ICP-OES). The ICP source, or torch, consists of three concentric quartz tubes with argon gas flowing through them. A spark from a Tesla coil initiates the ionization of argon, generating a high-temperature plasma.
    The ions and electrons produced interact with the fluctuating magnetic field created by a water-cooled...
    Atomic Emission Spectroscopy: Overview01:20

    Atomic Emission Spectroscopy: Overview

    Atomic emission spectroscopy (AES) is an analytical technique used to determine the elemental composition of a sample by analyzing the light emitted from excited atoms. In AES, atoms in a sample are excited to higher energy levels by thermal energy from high-temperature sources, such as plasma, arcs, or sparks. When these excited atoms return to lower energy states, they emit light at specific wavelengths characteristic of each element. The resulting atomic emission spectrum, which consists of...
    Atomic Emission Spectroscopy: Lab01:29

    Atomic Emission Spectroscopy: Lab

    AES is a powerful analytical technique, especially effective when used with plasma sources, producing abundant spectra in characteristic emission lines. The Inductively Coupled Plasma (ICP), in particular, yields superior quantitative analytical data due to its high stability, low noise, low background, and minimal interferences under optimal experimental conditions. However, newer air-operated microwave sources are emerging as promising alternatives that could be more cost-effective than...
    Inductively Coupled Plasma Atomic Emission Spectroscopy: Instrumentation01:26

    Inductively Coupled Plasma Atomic Emission Spectroscopy: Instrumentation

    Inductively coupled plasma (ICP) is the common plasma source used in atomic emission spectroscopy (AES), a technique that detects and analyzes various elements in a sample. This method is often called inductively coupled plasma atomic emission spectroscopy (ICP-AES).
    There are three main types of inductively coupled plasma atomic emission spectroscopy  (ICP-AES) instruments: sequential, simultaneous multichannel, and Fourier transform instruments, with the latter being less commonly used.
    Atomic Emission Spectroscopy: Instrumentation01:22

    Atomic Emission Spectroscopy: Instrumentation

    The instrumentation of atomic emission spectrometry (AES) involves various components, including atomization devices that convert samples into gas-phase atoms and ions. There are two main types of atomization devices: continuous and discrete atomizers.  Continuous atomizers, like plasmas and flames, introduce samples in a constant stream, while discrete atomizers inject individual samples using syringes or autosamplers. The most common discrete atomizer is the electrothermal atomizer.
    Standing Waves in a Cavity01:28

    Standing Waves in a Cavity

    A household microwave and lasers are examples of standing electromagnetic waves in a cavity. When two conducting metal plates are placed parallel at the nodal planes, it creates a cavity where standing waves are formed. The cavity between the two planes is analogous to a stretched string held at the points x = 0 and x = L. Here, the distance 'L' between the two planes must be an integer multiple of half of the wavelength. The wavelengths that satisfy this condition are given by: