Related Experiment Video

Updated: Jun 20, 2026

Fabrication and Characterization of Thickness Mode Piezoelectric Devices for Atomization and Acoustofluidics
10:39

Fabrication and Characterization of Thickness Mode Piezoelectric Devices for Atomization and Acoustofluidics

Published on: August 5, 2020

Explosive vaporization of single droplets by lasers: comparison of models with experiments

J C Carls, J R Brock

    Optics Letters
    |September 12, 2009
    PubMed

    More Related Videos

    Safe Experimentation in Optical Levitation of Charged Droplets Using Remote Labs09:09

    Safe Experimentation in Optical Levitation of Charged Droplets Using Remote Labs

    Published on: January 10, 2019

    Measuring Spray Droplet Size from Agricultural Nozzles Using Laser Diffraction08:14

    Measuring Spray Droplet Size from Agricultural Nozzles Using Laser Diffraction

    Published on: September 16, 2016

    Related Concept Videos

    Vaporization01:18

    Vaporization

    The physical form of a substance changes by changing its temperature. For example, raising the temperature of a liquid causes the liquid to vaporize (convert into vapor). The process is called vaporization—a surface phenomenon. For vaporization to occur, kinetic energy must be greater than the intermolecular forces that keep molecules bonded. The amount of energy needed to vaporize a quantity of liquid at a given pressure and a constant temperature is called the heat of vaporization. When...
    Phase Transitions: Vaporization and Condensation02:39

    Phase Transitions: Vaporization and Condensation

    The physical form of a substance changes on changing its temperature. For example, raising the temperature of a liquid causes the liquid to vaporize (convert into vapor). The process is called vaporization—a surface phenomenon. Vaporization occurs when the thermal motion of the molecules overcome the intermolecular forces, and the molecules (at the surface) escape into the gaseous state. When a liquid vaporizes in a closed container, gas molecules cannot escape. As these gas phase molecules...
    Atomic Absorption Spectroscopy: Atomization Methods01:25

    Atomic Absorption Spectroscopy: Atomization Methods

    Atomic Absorption Spectroscopy (AAS) atomizes samples through flame atomization or electrothermal atomization. Flame atomization typically involves a nebulizer and spray chamber assembly to combine the sample with a fuel–oxidant mixture, creating a fine aerosol mist that enters a burner. Typically, the fuel and oxidant are combined in an approximately stoichiometric ratio. However, for atoms that are easily oxidized, a fuel-rich mixture may be more advantageous. Only about 5% of the aerosol...
    Distillation: Vapor–Liquid Equilibria01:01

    Distillation: Vapor–Liquid Equilibria

    Distillation is a separation technique that takes advantage of the boiling point properties of disparate elements in a mixture. To perform distillation, we begin by heating a miscible mixture of two liquids with a significant difference in boiling points (at least 20°C). As the solution heats up and reaches the bubble point of the more volatile component, some molecules of the more volatile component transition into the gas phase and travel upward into the condenser, which is a glass tube with...
    Flame Photometry: Overview01:02

    Flame Photometry: Overview

    Flame photometry, also known as flame emission spectrometry, is a technique used for the qualitative and quantitative analysis of elements present in a sample using a flame as the source of excitation energy. The concept of flame photometry was realized in the early 1860s by Kirchhoff and Bunsen, who discovered that specific elements emit characteristic radiation when excited in flames. The first instrument developed for this purpose was used to measure sodium (Na) in plant ash using a Bunsen...
    Vapor Pressure02:34

    Vapor Pressure

    When a liquid vaporizes in a closed container, gas molecules cannot escape. As these gas phase molecules move randomly about, they will occasionally collide with the surface of the condensed phase, and in some cases, these collisions will result in the molecules re-entering the condensed phase. The change from the gas phase to the liquid is called condensation. When the rate of condensation becomes equal to the rate of vaporization, neither the amount of the liquid nor the amount of the vapor...