Structural dependence of redox-induced dimerization as studied by in situ ESR/UV/Vis-NIR spectroelectrochemistry: the fluoranthenopyracylene oligomers
Related Experiment Video
Updated: Jun 20, 2026
11:44
Using Cyclic Voltammetry, UV-Vis-NIR, and EPR Spectroelectrochemistry to Analyze Organic Compounds
Published on: October 18, 2018
Lothar Dunsch1, Peter Rapta, Niels Schulte
1IFW Dresden, Abteilung Elektrochemie und leitfähige Polymere, Dresden, Germany. l.dunsch@ifw-dresden.de
Angewandte Chemie (International Ed. in English)
|September 15, 2009
Abstract
No abstract available in PubMed .
Related Concept Videos
01:17Electron Paramagnetic Resonance (EPR) Spectroscopy: Organic Radicals
Ideally, an unpaired electron shows a single peak in the EPR spectrum due to the transition between the two spin energy states. However, coupling interactions can occur between the spins of the unpaired electron and any neighboring spin-active nuclei. This hyperfine coupling results in hyperfine splitting, where the EPR signal is split into multiplets. The signals split into 2nI + 1 peaks, where n is the number of equivalent nuclei and I is the nuclear spin. These splitting patterns provide...
01:26Photochemical Electrocyclic Reactions: Stereochemistry
The absorption of UV–visible light by conjugated systems causes the promotion of an electron from the ground state to the excited state. Consequently, photochemical electrocyclic reactions proceed via the excited-state HOMO rather than the ground-state HOMO. Since the ground- and excited-state HOMOs have different symmetries, the stereochemical outcome of electrocyclic reactions depends on the mode of activation; i.e., thermal or photochemical.
Selection Rules: Photochemical Activation
Selection Rules: Photochemical Activation
01:29UV–Vis Spectroscopy: Woodward–Fieser Rules
UV–Visible absorption spectra of conjugated dienes arise from the lowest energy π → π* transitions. The light-absorbing part of the molecule is called the chromophore, and the substituents directly attached to the chromophore are called auxochromes. A strong correlation exists between the absorption maxima, λmax, and the structure of a conjugated π system. The Woodward–Fieser rules predict the value of λmax for a given structure by adding the contributions...
01:26Thermal and Photochemical Electrocyclic Reactions: Overview
Electrocyclic reactions are reversible reactions. They involve an intramolecular cyclization or ring-opening of a conjugated polyene. Shown below are two examples of electrocyclic reactions. In the first reaction, the formation of the cyclic product is favored. In contrast, in the second reaction, ring-opening is favored due to the high ring strain associated with cyclobutene formation.
01:12Cycloaddition Reactions: MO Requirements for Photochemical Activation
Some cycloaddition reactions are activated by heat, while others are initiated by light. For example, a [2 + 2] cycloaddition between two ethylene molecules occurs only in the presence of light. It is photochemically allowed but thermally forbidden.
01:13Electrophilic Aromatic Substitution: Fluorination and Iodination of Benzene
Bromination and chlorination of aromatic rings by electrophilic aromatic substitution reactions are easily achieved, but fluorination and iodination are difficult to achieve. Fluorine is so reactive that its reaction with benzene is difficult to control, resulting in poor yields of monofluoroaromatic products. To address this, Selectfluor reagent is used as a fluorine source in which a fluorine atom is bonded to a positively charged nitrogen.