Related Experiment Video

Updated: Jun 20, 2026

Infrared Degenerate Four-wave Mixing with Upconversion Detection for Quantitative Gas Sensing
10:42

Infrared Degenerate Four-wave Mixing with Upconversion Detection for Quantitative Gas Sensing

Published on: March 22, 2019

Simultaneous measurement of Raman scattering and laser-induced OH fluorescence in nonpremixed turbulent jet flames

R S Barlow, R W Dibble, R P Lucht

    Optics Letters
    |September 15, 2009
    PubMed

    More Related Videos

    Simultaneous Measurement of Turbulence and Particle Kinematics Using Flow Imaging Techniques10:53

    Simultaneous Measurement of Turbulence and Particle Kinematics Using Flow Imaging Techniques

    Published on: March 12, 2019

    Related Concept Videos

    Flame Photometry: Overview01:02

    Flame Photometry: Overview

    Flame photometry, also known as flame emission spectrometry, is a technique used for the qualitative and quantitative analysis of elements present in a sample using a flame as the source of excitation energy. The concept of flame photometry was realized in the early 1860s by Kirchhoff and Bunsen, who discovered that specific elements emit characteristic radiation when excited in flames. The first instrument developed for this purpose was used to measure sodium (Na) in plant ash using a Bunsen...
    Raman Spectroscopy: Overview01:20

    Raman Spectroscopy: Overview

    The underlying principle of Raman spectroscopy is based on the interaction between light and matter, specifically molecules' inelastic scattering of photons. When a monochromatic beam of light, typically from a laser source, interacts with a sample, most scattered light has the same frequency as the incident light. This is known as Rayleigh scattering.
    However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and the...
    Raman Spectroscopy Instrumentation: Overview01:26

    Raman Spectroscopy Instrumentation: Overview

    A conventional Raman spectrophotometer includes a laser source, a sample holding system, a wavelength selector, and a detector.
    The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...
    Flame Photometry: Lab01:16

    Flame Photometry: Lab

    In a flame photometer, when a solution like potassium chloride is aspirated into the flame, the solvent evaporates, leaving behind dehydrated salt. This salt dissociates into free gaseous atoms in their ground state. Some of these atoms absorb energy from the flame, leading to their excitation. The excited atoms return to the ground state, emitting photons at characteristic wavelengths. Because only electronic transitions are involved, the resulting emission lines are very narrow. The intensity...