An experimental criterion for consistency in interpolation of partly occluded contours

Jacqueline M Fulvio1, Manish Singh, Laurence T Maloney

  • 1Department of Psychology, New York University, New York, NY 10003, USA. jmf384@nyu.edu

Journal of Vision
|September 18, 2009
PubMed

Related Concept Videos

Reconstruction of Signal using Interpolation01:10

Reconstruction of Signal using Interpolation

Signal processing techniques are essential for accurately converting continuous signals to digital formats and vice versa. When a continuous signal is sampled with a period T, the resulting sampled signal exhibits replicas of the original spectrum in the frequency domain, spaced at intervals equal to the sampling frequency. To handle this sampled signal, a zero-order hold method can be applied, which creates a piecewise constant signal by retaining each sample's value until the next sampling...
Boundary Conditions: Lossless Lines01:21

Boundary Conditions: Lossless Lines

Consider a single-phase, two-wire, lossless transmission line terminated by an impedance at the receiving end and a source with Thevenin voltage and impedance at the sending end. The line, with length, has a surge impedance and wave velocity determined by the line's inductance and capacitance.
At the receiving end, the boundary condition states that the voltage equals the product of the receiving-end impedance and current. This relationship is expressed as a function of the incident and...
Limits with Oscillating Discontinuities01:19

Limits with Oscillating Discontinuities

An oscillating discontinuity is a type of discontinuity in which a function’s values fluctuate infinitely often as the input approaches a particular point. Unlike jump discontinuities, where the function suddenly shifts between two values, or infinite discontinuities, where the function diverges without bound, an oscillating discontinuity arises from rapid back-and-forth variation. Because the function never stabilizes toward a single value, no finite limit exists at that point.One of the most...
Area Between Curves: Problem Solving01:27

Area Between Curves: Problem Solving

A region can be enclosed by three curves: a square root function, a reflected cube root function, and a linear function. The linear function intersects each of the other two curves, and these intersection points determine where the boundary of the enclosed region changes. Because different curves serve as the upper and lower boundaries in different parts of the graph, the area cannot be found using a single setup over the entire interval.To compute the area, the region is first divided into two...
Elevation of Intermediate Points on Vertical Curves01:20

Elevation of Intermediate Points on Vertical Curves

Vertical curves are essential in roadway design because they provide smooth transitions between varying roadway grades. Designing vertical curves involves calculating intermediate elevations and identifying the curve's highest or lowest point, which is essential for optimal roadway performance.Intermediate elevations on a vertical curve are determined using the tangent offset method. This method considers the initial elevation at the start of the curve, the grades, and the curve's geometry. The...
Midpoint Rule01:20

Midpoint Rule

Approximating areas under curved boundaries is a common problem in applied mathematics, particularly when an exact calculation is difficult or impractical. One effective numerical method for this purpose is the Midpoint Rule, which provides an estimate of the area under a curve by using rectangular approximations over a specified interval.Description of the Midpoint RuleThe Midpoint Rule begins by dividing the given interval into a number of equal subintervals. For each subinterval, the...