Finish line. Making the best selections in flooring, walls, hard surfaces and upholstery

Concrete finishing starts immediately after the concrete has been placed and consolidated. The initial step, screeding, involves leveling the concrete surface by removing excess material to flush it with the formwork's top. Following this, bull float or darby are employed to smooth the surface further, effectively lower high spots, fill low areas, and ensure larger aggregate particles are embedded within the concrete. This preparation is critical before the appearance of bleed water, as its...

Lumber is derived from logs which are harvested, debarked, and processed into long pieces with a rectangular cross-section. The transformation of logs into lumber involves multiple steps, beginning with an automated saw that slices the log into slabs. These slabs are then transported via a conveyor belt to smaller saws, where they are cut into square-edged pieces of specific widths.
Initially, the surfaces of these lumber pieces are rough, and their dimensions may vary slightly from one end to...

Wood surfacing is a critical finishing process designed to smoothen the wood surface, enhance its dimensional accuracy, and make handling safer. This process compensates for potential shrinkage during the seasoning phase by marginally increasing the wood dimensions before surfacing. It also helps correct some distortions that may occur as the wood dries.
The equipment used in the surfacing process is a plane equipped with rotating blades. This tool efficiently smoothens the wood surface and can...

Wood panel products are essential materials used in construction for applications such as flooring, siding, and roofing, typically available in standard dimensions of 4 feet by 8 feet, with thicknesses varying from one-quarter of an inch to one and one-eighth inches. Among the most common types of wood panels is plywood, which is produced by gluing multiple layers of thin wood veneers under pressure. The grain of the outer veneers runs lengthwise, while the grains of the interior layers run...

Softwoods and hardwoods, derived from different types of trees, are distinguished by their leaf structures and cellular compositions, each serving unique purposes in construction and manufacturing. Softwoods come from cone-bearing trees with needle-like leaves and are predominantly composed of longitudinal cells called tracheids and a smaller proportion of radial cells known as rays. Due to their cellular structure, softwoods are commonly used in construction for structural frames, sheathing,...

Veneer refers to a thin sheet of wood, typically produced to a thickness of about one-eighth of an inch or less. This material is crafted through various methods, the most common being rotary cutting. In this process, a log is mounted into a large lathe and spun against a knife edge, peeling off a continuous strip of wood as the knife penetrates deeper into the rotating log, creating a rotary-cut veneer.
Other veneering techniques include plain-slicing, quarter-slicing, and rift-slicing. These...