Related Experiment Video
Updated: Jun 20, 2026
One-Step Approach to Fabricating Polydimethylsiloxane Microfluidic Channels of Different Geometric Sections by Sequential Wet Etching Processes
Published on: September 13, 2018
Enhancement of electrokinetically driven microfluidic T-mixer using frequency modulated electric field and channel
Deguang Yan1, Chun Yang, Jianmin Miao
1School of Mechanical and Aerospace Engineering, Nanyang Technological University, Singapore, Singapore.
Abstract:
This study reports improved electrokinetically driven microfluidic T-mixers to enhance their mixing efficiency. Enhancement of electrokinetic microfluidic T-mixers is achieved using (i) an active approach of utilizing a pulsating EOF, and (ii) a passive approach of using the channel geometry effect with patterned blocks. PDMS-based electrokinetic T-mixers of different designs were fabricated. Experimental measurements were carried out using Rhodamine B to examine the mixing performance and the micro-particle image velocimetry technique to characterize the electrokinetic flow velocity field. Scaling analysis provides an effective frequency range of applied AC electric field. Results show that for a T-mixer of 10 mm mixing length, utilizing frequency modulated electric field and channel geometry effects can increase the mixing efficiency from 50 to 90%. In addition, numerical simulations were performed to analyze the mixing process in the electrokinetic T-mixers with various designs. The simulation results were compared with the experimental data, and reasonable agreement was found.
