Related Experiment Video
Updated: Jun 19, 2026

Characterizing Far-infrared Laser Emissions and the Measurement of Their Frequencies
Published on: December 18, 2015
Self-frequency-doubled KTiOAsO4 Raman laser emitting at 573 nm
Zhaojun Liu1, Qingpu Wang, Xingyu Zhang
1School of Information Science and Engineering, Shandong University, Jinan, China.
Abstract:
A self-frequency-doubled KTiOAsO4 (KTA) Raman laser is realized in a diode-end-pumped acousto-optically Q-switched intracavity Raman laser configuration. A 30-mm-long x-cut KTA crystal is used as the Raman medium, and its 671 cm(-1) Raman mode is employed to finish the conversion from 1064 nm fundamental laser to 1146 nm Raman laser. Self-frequency doubling of the Raman laser is accomplished in the same KTA crystal, and a 573 nm yellow laser is obtained. With an incident diode power of 10.9 W and a pulse repetition rate of 20.8 kHz, a yellow-laser power of 0.82 W is obtained. The conversion efficiency from diode power to yellow-laser power is 7.5%.
Related Concept Videos
Raman Spectroscopy Instrumentation: Overview
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...
Raman Spectroscopy: Overview
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and the...
IR Absorption Frequency: Hybridization
Among the sp, sp2, and sp3 hybridized orbitals, sp orbitals have the maximum s character (50%). Consequently, the electrons are held more closely to the nucleus, resulting in stronger and shorter C–H bonds that stretch at a...
IR Absorption Frequency: Delocalization
In IR spectroscopy,...
