Related Experiment Video
Updated: Jun 19, 2026
Scanning Electron Microscopic Evaluation of Surface Defects of Remover Retreatment File After Single and Multiple Uses
Published on: October 11, 2024
Rotary nickel-titanium GT and ProTaper files for root canal shaping by novice operators: a radiographic and
Diana Gekelman1, Ramya Ramamurthy, Sahar Mirfarsi
1Division of Endodontics, Department of Preventive and Restorative Dental Sciences, University of California School of Dentistry, San Francisco, California 94143-0758, USA. gekelmand@dentistry.ucsf.edu
Introduction:
The purpose of this study was to assess canal preparation outcomes in vitro by novice clinicians after standardized teaching sessions.
Methods:
All students received a training session. In experiment 1, twenty canals of mandibular molars were prepared with GT and ProTaper rotaries by 10 students. Standardized radiographs were exposed before and after canal preparation, and canal curvature was measured; canals were assessed for patency and preparation time. In experiment 2, mandibular molars (20 canals) were submitted to microcomputed tomography before and after canal preparation with ProTaper and GT rotaries by 2 dental students. Canals were metrically assessed for changes (volume, surface, cross-sectional shape, transportation) during canal preparation by using software.
Results:
In experiment 1, canal curvature decreased by 7.6 degrees and 7.8 degrees for GT and ProTaper preparations; there were no broken instruments, and 2 canals lost patency. The time for GT preparation was longer than for ProTaper (29.7 +/- 6.8 vs 19.4 +/- 8.1 minutes, P <.05). In experiment 2, canal volumes and surface areas increased (P < .001), and prepared canals were rounder in cross-section and more tapered. Mean canal transportation ranged between 0.14 +/- 0.05 mm and 0.23 +/- 0.09 mm for apical and coronal canal thirds. There were no significant differences between the instruments or the operators regarding center of mass shifts; qualitative and quantitative data for canal transportation were similar to earlier studies with experienced operators.
Conclusions:
Both rotary instruments performed adequately with inexperienced operators who received a brief structured training session.
