Related Experiment Video
Updated: Jun 19, 2026

Experimental Protocol to Investigate Particle Aerosolization of a Product Under Abrasion and Under Environmental Weathering
Published on: September 16, 2016
Morphology hypothesized to influence aerosol particle deliquescence
A L Mifflin1, M L Smith, S T Martin
1School of Engineering and Applied Sciences & Department of Earth and Planetary Sciences, Harvard University, Cambridge, Massachusetts, USA.
Abstract:
The deliquescence phase transitions of populations of internally mixed particles of solid ammonium bisulfate and letovicite, having overall extents of neutralization between 0.60 and 0.75 and diameters between 15 and 60 nm, were studied using a hygroscopic tandem nano-differential mobility analyzer (HTnDMA). Populations having particles sufficiently small or large, as well as particles sufficiently acidic or neutralized, behaved as expected, with prompt transitions of all particles at a single relative humidity. Populations having particles of simultaneously intermediate diameter and acidity, however, behaved differently and unexpectedly. Subpopulations of individual particles did exhibit prompt deliquescence but did so over a broad range of relative humidity (RH) for the entire population. For example, some particles of 20-nm diameter and an extent of neutralization of 0.65 deliquesced promptly at as low as 38% RH, whereas some particles in the same experiment deliquesced promptly at as high as 59% RH. Across this 21% RH span, prompt deliquescence of particle subpopulations was observed, which resulted in the continuous deliquescence of the population as the aerosol progressed from dominantly solid to dominantly aqueous particles for increasing RH. Morphological differences among particles in different subpopulations that drive variable rates of water uptake, such as coatings of letovicite of varying thickness, porosity, and hence water permeability on cores of ammonium bisulfate, are hypothesized to explain these observations.
Related Concept Videos
Precipitate Formation and Particle Size Control
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...
The Colloidal State
Factors Affecting Dissolution: Particle Size and Effective Surface Area
Colloidal precipitates
Theories of Dissolution: Diffusion Layer Model
This process starts with a thin layer, saturated with the drug, forming at the interface between the solid and liquid. The solute then diffuses from this layer into the main solution. The Noyes-Whitney equation suggests that the rate of dissolution relies on the diffusion...
Factors Affecting Dissolution: Polymorphism, Amorphism and Pseudopolymorphism
Some polymorphic crystals possess lower aqueous solubility than their amorphous counterparts, leading to incomplete absorption. For instance, the oral suspension of Chloramphenicol, which...

