Related Experiment Video
Updated: Jun 18, 2026

A Millimeter Scale Flexural Testing System for Measuring the Mechanical Properties of Marine Sponge Spicules
Published on: October 11, 2017
On the difference between the transition properties calculated with linear response- and equation of motion-CCSD
Marco Caricato1, Gary W Trucks, Michael J Frisch
1Department of Chemistry, Yale University, 225 Prospect St., New Haven, Connecticut 06511, USA. marco.caricato@yale.edu
Abstract:
In this work, we quantitatively investigate the difference between the linear response (LR) and the equation of motion (EOM) coupled cluster (CC) approaches in the calculation of transition properties, namely, dipole and oscillator strengths, for the most widely used truncated CC wave function, which includes single and double excitation operators. We compare systems of increasing size, where the size-extensivity may be important. Our results suggest that, for small molecules, the difference is small even with large basis sets. The difference increases with the size of the system, but it is numerically small until hundreds of electron pairs are correlated. Although these calculations may be possible in a few years, at present the EOM approach is more advantageous, albeit more approximate, because it is computationally less demanding.
Related Concept Videos
Linear Approximation in Frequency Domain
In contrast, nonlinear systems do not inherently possess these properties. However, for small deviations around an operating point, a nonlinear system can often be approximated as linear.
Linear Approximation in Time Domain
For a simple pendulum with a mass evenly distributed along its length and the center of mass located at half the pendulum's length, the...
Equations of Motion: Rectangular Coordinates and Cylindrical Coordinates
When a particle moves relative to an inertial frame, the equations of motion can be expressed using rectangular components. If the motion is confined to the x-y plane, the equations having the x and y coordinates only can be used to simplify the mathematical representation.
However, when particles...
Classification of Systems-I
Homogeneity dictates that if an input x(t) is multiplied by a constant c, the output y(t) is multiplied by the same constant. Mathematically, this is expressed as:
Transient and Steady-state Response
These test signals are integral in designing control systems to exhibit two key performance aspects: transient response and steady-state response.
Types of Responses of Series RLC Circuits

