Related Experiment Video
Updated: Jun 18, 2026

A Hydrogel Construct and Fibrin-based Glue Approach to Deliver Therapeutics in a Murine Myocardial Infarction Model.
Published on: June 14, 2015
Why the carioprotective potential of luting cements crucial?
M Rohilla1, I K Pandit, N Srivastava
1Government Dental College, Rohtak, India. monikarohilla@yahoo.co.in
Abstract:
Space maintainers make good oral hygiene difficult, modify the oral environment, and increase the chances of enamel demineralization. Demineralization can be prevented or reduced by improving patient oral hygiene or by using topical fluorides. However these methods depend on patient compliance and, therefore, are not very reliable. Thus, caries prevention in banding might be enhanced by using fluoride-releasing cements. The aim of the study was to comparatively evaluate the carioprotective potential of various luting media used for band cementation in permanent as well as deciduous molars. In this study, 100 molars were taken, which were banded and stored in artificial saliva for 1 month after which the teeth were debanded. An area of 2 x 2 mm was spared and the teeth were coated with nail varnish. The coated teeth were dipped in artificial caries solution in one month followed by 1-day immersion in methylene blue dye, after which the samples were sectioned through the window. The depth of dye penetration was measured and the results were statistically analyzed. Minimum dye penetration was observed with glass ionomer, which could be due to the fluoride release from the cement, whereas the control group showed the maximum, probably due to direct contact with the artificial caries solution.
Related Concept Videos
Cardiomyopathy V: Interprofessional Care
Types of Cement I
Type I (Ordinary Portland Cement) is widely used for general construction where special properties are not required. It has moderate sulfate resistance and heat of hydration.
Type II (Modified Cement) offers moderate resistance to sulfate attack and a lower rate of heat development compared to Type I. It is suitable for structures in...
Plasticizers
Plasticizers function by using surface-active agents to create repulsive electrostatic forces between cement particles. This dispersion enhances the concrete's...
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in ASTM C...