Related Experiment Video

Updated: Jun 18, 2026

Ultrasonic-Assisted Preparation of Biodiesel Products from Vegetable Oils
04:40

Ultrasonic-Assisted Preparation of Biodiesel Products from Vegetable Oils

Published on: April 19, 2024

Emissions characteristics of a diesel engine operating on biodiesel and biodiesel blended with ethanol and methanol

Lei Zhu1, C S Cheung, W G Zhang

  • 1Department of Mechanical Engineering, The Hong Kong Polytechnic University, Hong Kong, China.

The Science of the Total Environment
|November 21, 2009
PubMed

More Related Videos

Original Experimental Approach for Assessing Transport Fuel Stability09:48

Original Experimental Approach for Assessing Transport Fuel Stability

Published on: October 21, 2016

Experimental Protocol for Biodiesel Production with Isolation of Alkenones as Coproducts from Commercial Isochrysis Algal Biomass09:10

Experimental Protocol for Biodiesel Production with Isolation of Alkenones as Coproducts from Commercial Isochrysis Algal Biomass

Published on: June 24, 2016

Related Concept Videos

Biofuels01:25

Biofuels

The microbial conversion of organic matter into biofuels holds potential as a renewable energy source. Among biofuel sources, microalgae are recognized as a highly efficient and adaptable feedstock for biodiesel production, owing to their rapid biomass accumulation, elevated lipid productivity, and capacity to proliferate in diverse aquatic systems, including freshwater, marine, and wastewater habitats. Unlike terrestrial crops, microalgae do not compete for land and can achieve significantly...
Otto and Diesel Cycle01:27

Otto and Diesel Cycle

An Otto engine is a four-stroke engine that uses a mixture of gasoline and air as the working fuel. The fuel is injected into the cylinder, and the piston is moved completely down so that the cylinder is at maximum volume. By moving the piston up, adiabatic compression takes place. The spark plug ignites the gasoline-air mixture, and the burning fuel adds heat to the system at a constant volume. The heated mixture expands adiabatically and gets further cooled by exhausting heat, and this cyclic...
Turnover Number and Catalytic Efficiency01:19

Turnover Number and Catalytic Efficiency

The turnover number of an enzyme is the maximum number of substrate molecules it can transform per unit time. Turnover numbers for most enzymes range from 1 to 1000 molecules per second. Catalase has the known highest turnover number, capable of converting up to 2.8×106 molecules of hydrogen peroxide into water and oxygen per second. Lysozyme has the lowest known turnover number of half a molecule per second.
Chymotrypsin is a pancreatic enzyme that breaks down proteins during digestion. The...
Internal Combustion Engine01:20

Internal Combustion Engine

The internal combustion engine is a heat engine that uses the byproducts of combustion as the working fluid instead of using a heat transfer medium to transfer heat. The combustion is done in a way that produces high-pressure combustion products that can be expanded through a turbine or piston to create work. Internal combustion engines can again be categorized into three kinds: (1) spark ignition gasoline engines, most commonly used in automobiles, (2) compression ignition diesel engines that...
Physical Properties of Ethers02:17

Physical Properties of Ethers

Overview
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...
Batteries and Fuel Cells03:12

Batteries and Fuel Cells

A battery is a galvanic cell that is used as a source of electrical power for specific applications. Modern batteries exist in a multitude of forms to accommodate various applications, from tiny button batteries such as those that power wristwatches to the very large batteries used to supply backup energy to municipal power grids. Some batteries are designed for single-use applications and cannot be recharged (primary cells), while others are based on conveniently reversible cell reactions that...