Related Experiment Video
Updated: Jun 18, 2026

Macro-Rheology Characterization of Gill Raker Mucus in the Silver Carp, Hypophthalmichthys molitrix
Published on: July 10, 2020
Dynamic rheology of sphere- and rod-based magnetorheological fluids
J de Vicente1, J P Segovia-Gutiérrez, E Andablo-Reyes
1Department of Applied Physics, Faculty of Sciences, University of Granada, C/Fuentenueva s/n, Granada 1807, Spain. jvicente@ugr.es
Abstract:
The effect of particle shape in the small amplitude oscillatory shear behavior of magnetorheological (MR) fluids is investigated from zero magnetic field strengths up to 800 kA/m. Two types of MR fluids are studied: the first system is prepared with spherical particles and a second system is prepared with rodlike particles. Both types of particles are fabricated following practically the same precipitation technique and have the same intrinsic magnetic and crystallographic properties. Furthermore, the distribution of sphere diameters is very similar to that of rod thicknesses. Rod-based MR fluids show an enhanced MR performance under oscillatory shear in the viscoelastic linear regime. A lower magnetic field strength is needed for the structuration of the colloid and, once saturation is fully achieved, a larger storage modulus is observed. Existing sphere- and rod-based models usually underestimate experimental results regarding the magnetic field strength and particle volume fraction dependences of both storage modulus and yield stress. A simple model is proposed here to explain the behavior of microrod-based MR fluids at low, medium and saturating magnetic fields in the viscoelastic linear regime in terms of magnetic interaction forces between particles. These results are further completed with rheomicroscopic and dynamic yield stress observations.
Related Concept Videos
Types of Fluids
In contrast, non-Newtonian fluids do not follow Newton's law of viscosity, and their...
Newtonian Fluid: Problem Solving
A velocity gradient forms within the fluid when a Newtonian fluid is placed between two parallel plates, with...
Temperature Dependent Deformation
Fluid Mosaic Model
Magnetic Damping
If, however, the bob is a slotted metal plate, the magnet produces a much smaller effect. When a slotted metal plate enters the field, an emf is induced by the change in flux; however, it is less effective because the slots limit the...
Magnetostatic Boundary Conditions
