Related Experiment Video
Updated: Jun 18, 2026

An Anaerobic Biosensor Assay for the Detection of Mercury and Cadmium
Published on: December 17, 2018
Substantial emission of gaseous monomethylmercury from contaminated water-sediment microcosms
Sofi Jonsson1, Ulf Skyllberg, Erik Björn
1Department of Chemistry, Umeå University, SE-901 87 Umeå, Sweden.
Abstract:
Emission rates of gaseous monomethylmercury (CH(3)Hg(II)), as well as elemental mercury (Hg(0)) and dimethylmercury [(CH(3))(2)Hg(II)], were determined in Hg-contaminated water-sediment microcosms (duplicates of three treatments) by gaseous species-specific isotope dilution analysis (SSIDA). Incubation of approximately 500 g (wet mass) of sediments containing 30 mumol of ambient Hg with an addition of 2.6 mumol of (201)Hg(II) tracer resulted in average (n = 6) gaseous emissions of 84 +/- 26, 100 +/- 37, and 830 +/- 380 pmol of ambient CH(3)Hg(II), CH(3)(201)Hg(II), and (201)Hg(0), respectively, during 108 days of incubation. In contrast to Hg(0), a transient temporal pattern was observed for measured CH(3)Hg(II) emission rates, which peaked at day 12 and decreased to much lower levels by the end of the experiments. At day 12, CH(3)Hg(II) constituted 30-50% of the total emitted gaseous Hg, emphasizing the significance of this species to total Hg emissions from anoxic sediment-water systems. Emission rates of gaseous CH(3)Hg(II) did not reflect the accumulated CH(3)Hg(II) content in the sediment, suggesting that emissions mainly originated from newly methylated Hg(II). Speciation modeling of the pore water suggests that CH(3)Hg(II) was emitted as CH(3)HgSH(0)(g).
Related Concept Videos
Marine Microbial Ecology
Microbial Wastewater Treatment
Acid Mine Drainage
Microbial Bioremediation of Hydrocarbons
Deep Sea Microbial Ecology
Microbes and Climate Change
