Related Experiment Video
Updated: Jun 18, 2026
Reverse Total Shoulder Arthroplasty
Published on: July 5, 2011
Accuracy of CT-based measurements of glenoid version for total shoulder arthroplasty
Heinz R Hoenecke1, Juan C Hermida, Cesar Flores-Hernandez
1Shiley Center for Orthopaedic Research and Education at Scripps Clinic, La Jolla, CA 92037, USA. Hoenecke.Heinz@scrippshealth.org
Background/Hypothesis:
The arthritic glenoid is typically in retroversion and restoration to neutral version is recommended. While a method for measurement of glenoid version using axial computed tomography (CT) has been reported and has been widely accepted, its accuracy and reproducibility has not been established.
Methods:
In 33 patients scheduled for shoulder arthroplasty, glenoid version and maximum wear of the glenoid articular surface were measured with respect to the scapular body axis on 2-dimensional- (2D) CT slices as well as on 3-dimensional- (3D) reconstructed models of the same CT slices.
Results:
Clinical CT scans were axially aligned with the patient's torso but were almost never perpendicular to the scapular body. The average absolute error in version measured on the 2D-CT slice passing through the tip of the coracoid was 5.1 degrees (range, 0 - 16 degrees , P < .001). On high-resolution 3D-CT reconstructions, the location of maximum wear was most commonly posterior and was missed on the clinical 2D-CT slices in 52% of cases.
Conclusion:
Error in measuring version and depth of maximum wear can substantially affect the determination of the degree of correction necessary in arthritic glenoids. Accurately measuring glenoid version and locating the direction of maximum wear requires a full 3D-CT reconstruction and analysis.
