Developmental biology: Asymmetry with a twist

The development of all multicellular organisms starts with the fusion of haploid cells called sperm and egg to form a diploid zygote. A zygote is a totipotent cell that can develop into a complete organism. The zygote undergoes cell division or cleavage to form an 8-cell mass. Until this stage, the cells are spherical, loosely attached, and remain totipotent. Totipotent cells are capable of developing both the embryonic and the extraembryonic tissues. However, as they continue to divide, they...

After a large-single-celled zygote is produced via fertilization, the process of cleavage occurs while zygotes travel through the uterine tube. Cleavage is a mitotic cell division that does not result in growth. With each round of successive cell division, daughter cells get increasingly smaller.

Nondisjunction is the failure of homologous chromosomes or sister chromatids to separate correctly and move to the opposite poles of the cells. This produces daughter cells with abnormal chromosome numbers.  Nondisjunction is common during anaphase I or anaphase II of meiosis.  Mutations in synaptonemal complex proteins that attach homologous chromosomes increase the chances of nondisjunction in anaphase I of meiosis I. In contrast, mutations in topoisomerases and condensins that hold sister...

During meiosis, chromosomes occasionally separate improperly. This occurs due to failure of homologous chromosome separation during meiosis I or failed sister chromatid separation during meiosis II. In some species, notably plants, nondisjunction can result in an organism with an entire additional set of chromosomes, which is called polyploidy. In humans, nondisjunction can occur during male or female gametogenesis and the resulting gametes possess one too many or one too few chromosomes.

Gastrulation establishes the three primary tissues of an embryo: the ectoderm, mesoderm, and endoderm. This developmental process relies on a series of intricate cellular movements, which in humans transforms a flat, “bilaminar disc” composed of two cell sheets into a three-tiered structure. In the resulting embryo, the endoderm serves as the bottom layer, and stacked directly above it is the intermediate mesoderm, and then the uppermost ectoderm. Respectively, these tissue strata will form...

The upper and lower limb initially develops as a small bulge called a limb bud, which appears on the lateral side of the early embryo. The upper limb bud appears near the end of the fourth week of development, with the lower limb bud appearing shortly after.
Initially, the limb buds consist of a core of mesenchyme covered by a layer of ectoderm. The ectoderm at the end of the limb bud thickens to form a narrow crest called the apical ectodermal ridge. This ridge stimulates the underlying...