Instructiveness of real patients and simulated patients in undergraduate medical education: a randomized experiment

Lonneke Bokken1, Jan-Joost Rethans, Quirijn Jöbsis

  • 1Department of Educational Development and Research, Faculty of Health, Medicine and Life Sciences, Maastricht University, Maastricht, The Netherlands. L.Bokken@EDUC.unimaas.nl

Abstract

Related Concept Videos

Blinding01:11

Blinding

Blinding is a commonly used method of not telling participants which treatment a subject is receiving. Blinding is a critical part of a randomized control trial or RCT. It reduces the bias that affects the results. In an RCT, blinding is used in the form of a placebo. A placebo effect occurs when untreated subjects falsely believe they have received the treatment and report improved symptoms. A placebo or a dummy treatment is administered to subjects to negate the bias caused by such an effect.
Randomized Experiments01:13

Randomized Experiments

The randomization process involves assigning study participants randomly to experimental or control groups based on their probability of being equally assigned. Randomization is meant to eliminate selection bias and balance known and unknown confounding factors so that the control group is similar to the treatment group as much as possible. A computer program and a random number generator can be used to assign participants to groups in a way that minimizes bias.
Simple randomization
Simple...
Blind Procedures02:07

Blind Procedures

Ideally, the people who observe and record the children’s behavior are unaware of who was assigned to the experimental or control group, in order to control for experimenter bias. Experimenter bias refers to the possibility that a researcher’s expectations might skew the results of the study. Remember, conducting an experiment requires a lot of planning, and the people involved in the research project have a vested interest in supporting their hypotheses. If the observers knew which child was...
What is an Experiment?01:12

What is an Experiment?

An experiment is a planned activity carried out under controlled conditions. The purpose of an experiment is to investigate the relationship between two variables. When one variable causes change in another, we call the first variable the explanatory or independent variable. The affected variable is called the response or dependent variable. In a randomized experiment, the researcher manipulates values of the explanatory variable and measures the resulting changes in the response variable. The...
Group Design02:01

Group Design

The most basic experimental design involves two groups: the experimental group and the control group. The two groups are designed to be the same except for one difference— experimental manipulation. The experimental group gets the experimental manipulation—that is, the treatment or variable being tested—and the control group does not. Since experimental manipulation is the only difference between the experimental and control groups, we can be sure that any differences between the two are due to...
Bioequivalence Experimental Study Designs: Repeated Measures, Cross-Over, Carry-Over, and Latin Square Designs01:15

Bioequivalence Experimental Study Designs: Repeated Measures, Cross-Over, Carry-Over, and Latin Square Designs

Bioequivalence experimental study designs play a pivotal role in testing the effectiveness of various treatments. Key among these are the repeated measures, cross-over, carry-over, and Latin square designs. In the repeated measures design, each subject receives all treatments, allowing for temporal comparisons. This type of design is useful in reducing variability but requires careful planning to avoid bias.The cross-over design, an economical method, involves sequential administration of...