Related Experiment Video
Updated: Jun 16, 2026

Dependence of Laser-induced Breakdown Spectroscopy Results on Pulse Energies and Timing Parameters Using Soil Simulants
Published on: September 23, 2013
Simultaneous Raman spectroscopy-laser-induced breakdown spectroscopy for instant standoff analysis of explosives
Javier Moros1, Juan Antonio Lorenzo, Patricia Lucena
1Department of Analytical Chemistry, Faculty of Sciences, University of Málaga, E29071 Málaga, Spain.
Abstract:
A novel experimental design combining Raman spectroscopy and laser-induced breakdown spectroscopy (LIBS) in a unique integrated sensor is described. The sensor presented herein aims to demonstrate the applicability of a hybrid dual Raman-LIBS system as an analytical tool for the standoff analysis of energetic materials. Frequency-doubled 532 nm Nd:YAG nanosecond laser pulses, first expanded and then focused using a 10x beam expander on targets located at 20 m, allowed simultaneous acquisition of Raman-LIBS spectra for 4-mononitrotoluene (MNT), 2,6-dinitrotoluene (DNT), 2,4,6-trinitrotoluene (TNT), cyclotrimethylenetrinitramine (RDX), C4 and H15 (plastic explosives containing 90% and 75% of RDX by weight, respectively), and Goma2-ECO (Spanish denominated dynamite class high explosive mainly composed of ammonium nitrate, nitroglycol, and dinitrotoluene among other compounds), sodium chlorate, and ammonium nitrate. With the use of a Cassegrain telescope, both Raman and LIBS signals from the same laser pulses were collected and conducted through a bifurcated optical fiber into two identical grating spectrographs coupled to intensified charge-coupled device (iCCD) detectors. With the use of the appropriate timing for each detection mode, adjustment of the laser power on the beam focal conditions is not required. The ability of the present single hybrid sensor to simultaneously acquire, in real time, both molecular and multielemental information from the same laser pulses on the same cross section of the sample at standoff distances greatly enhances the information power of this approach.
More Related Videos
09:40Measurement and Analysis of Atomic Hydrogen and Diatomic Molecular AlO, C2, CN, and TiO Spectra Following Laser-induced Optical Breakdown
Published on: February 14, 2014
07:57Quantitative Detection of Trace Explosive Vapors by Programmed Temperature Desorption Gas Chromatography-Electron Capture Detector
Published on: July 25, 2014
Related Concept Videos
Raman Spectroscopy Instrumentation: Overview
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...
Raman Spectroscopy: Overview
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and the...
Tandem Mass Spectrometry
Atomic Emission Spectroscopy: Lab
Inductively Coupled Plasma Atomic Emission Spectroscopy: Instrumentation
There are three main types of inductively coupled plasma atomic emission spectroscopy (ICP-AES) instruments: sequential, simultaneous multichannel, and Fourier transform instruments, with the latter being less commonly used.
Rapid Identification of Pathogens