Preparation of activated carbons from unburnt coal in bottom ash with KOH activation for liquid-phase adsorption

Feng-Chin Wu1, Pin-Hsueh Wu, Ru-Ling Tseng

  • 1Department of Chemical Engineering, National United University, Miao-Li 360, Taiwan.

Related Concept Videos

Sample Preparation for Analysis: Advanced Techniques01:08

Sample Preparation for Analysis: Advanced Techniques

Accurate analysis of complex samples often requires advanced preparation techniques to achieve reliable and reproducible results. Samples containing inorganic or organic materials can be challenging to dissolve or decompose effectively. Standard sample preparation methods include acid digestion, fusion, dry ashing, and wet digestion.
Acid digestion with strong acids is commonly used to dissolve inorganic materials that are insoluble (do not dissolve) in water. This method can be useful for...
Aldehydes and Ketones to Alkanes: Wolff–Kishner Reduction01:09

Aldehydes and Ketones to Alkanes: Wolff–Kishner Reduction

Wolff–Kishner reduction involves converting aldehydes and ketones to alkanes using hydrazine and a base. The reaction converts a carbonyl group to a methylene group. The method was independently discovered by N. Kishner in 1911 and L. Wolff in 1912. The reduction is carried out in high-boiling solvents such as ethylene glycol and diethylene glycol because heat is required to deprotonate the N–H proton in one of the reaction steps.
Adsorption of Gases on Solids01:28

Adsorption of Gases on Solids

Adsorption is a process where molecules, known as the adsorbates, accumulate on a surface, which is referred to as the adsorbent or substrate. Occurring at the solid-gas interface, this phenomenon is crucial in various scientific and industrial contexts. The reverse of adsorption is desorption.Two types of adsorptions exist: physical (physisorption) and chemical (chemisorption). Physisorption involves gas molecules held to the solid's surface by relatively weak intermolecular van der Waals...
Atomic Absorption Spectroscopy: Atomization Methods01:25

Atomic Absorption Spectroscopy: Atomization Methods

Atomic Absorption Spectroscopy (AAS) atomizes samples through flame atomization or electrothermal atomization. Flame atomization typically involves a nebulizer and spray chamber assembly to combine the sample with a fuel–oxidant mixture, creating a fine aerosol mist that enters a burner. Typically, the fuel and oxidant are combined in an approximately stoichiometric ratio. However, for atoms that are easily oxidized, a fuel-rich mixture may be more advantageous. Only about 5% of the aerosol...
Preparation of Carboxylic Acids: Overview01:31

Preparation of Carboxylic Acids: Overview

There are various methods for the preparation of carboxylic acids. For example, oxidation of primary alcohols or aldehydes using strong oxidizing agents results in a carboxylic acid. Aldehydes can also be oxidized in the presence of mild oxidizing agents.