Related Experiment Video
Updated: Jun 16, 2026
Continuous Telemetric In Utero Tracheal Pressure Measurements in Fetal Lambs
Published on: December 22, 2023
Learning curve for lung area to head circumference ratio measurement in fetuses with congenital diaphragmatic hernia
R Cruz-Martinez1, F Figueras, O Moreno-Alvarez
1Fetal and Perinatal Medicine Research Group, Department of Maternal-Fetal Medicine, Hospital Clinic-IDIBAPS, University of Barcelona and Centre for Biomedical Research on Rare Diseases (CIBER-ER), Barcelona, Spain.
Objective:
To assess the learning curve for the fetal lung area to head circumference ratio (LHR) calculation in fetuses with congenital diaphragmatic hernia (CDH).
Methods:
Three trainees with the theoretical knowledge, but without prior experience in the LHR measurement, were selected. Each trainee and one experienced examiner measured the observed to expected (O/E)-LHR in the lung contralateral to the side of the hernia by two methods-manual tracing of lung borders and multiplication of the longest diameters-in a cohort of 95 consecutive CDH fetuses. The average difference between the three trainees and the expert in the O/E-LHR measurement was calculated. A difference below 10% was considered to indicate an accurate measurement. The average learning curve was delineated using cumulative sum analysis (CUSUM).
Results:
The CUSUM plots demonstrate that the learning curve was achieved by 77 and 72 tests performed for the area obtained by the manual-tracing and multiplication-of-the-longest-diameter methods, respectively.
Conclusion:
The minimum number of scans required for an inexperienced trainee to become competent in examining the LHR is on average 70.