Related Experiment Video

Updated: Jun 16, 2026

Investigating the Relationship between Sea Surface Chlorophyll and Major Features of the South China Sea with Satellite Information
10:28

Investigating the Relationship between Sea Surface Chlorophyll and Major Features of the South China Sea with Satellite Information

Published on: June 13, 2020

Influence of bottom depth and albedo on the diffuse reflectance of a flat homogeneous ocean

H R Gordon, O B Brown

    Applied Optics
    |February 6, 2010
    PubMed

    More Related Videos

    Evolution of Staircase Structures in Diffusive Convection07:28

    Evolution of Staircase Structures in Diffusive Convection

    Published on: September 5, 2018

    Measurement of Particle Size Distribution in Turbid Solutions by Dynamic Light Scattering Microscopy09:16

    Measurement of Particle Size Distribution in Turbid Solutions by Dynamic Light Scattering Microscopy

    Published on: January 9, 2017

    Related Concept Videos

    Influence of Earth's Curvature and Atmospheric Refraction on Leveling01:26

    Influence of Earth's Curvature and Atmospheric Refraction on Leveling

    During leveling, the Earth's curvature and atmospheric refraction introduce deviations in the line of sight from a true horizontal reference. When the line of sight is leveled, it remains perpendicular to the plumb line only at a single point. Beyond this, it deviates due to the Earth’s curvature, represented by the correction C. For a sight distance D, the deviation can be derived using the relationship:This relationship shows that the deviation increases quadratically with distance. Over a...
    Marine Microbial Ecology01:30

    Marine Microbial Ecology

    Marine microbial ecosystems are shaped by distinct physicochemical limits, including high salinity, low nutrient availability, and fluctuating oxygen levels. These conditions favor smaller microbial cell sizes, which maximize their surface-to-volume ratio for efficient nutrient uptake.Microbial activity and community composition are closely linked to biogeochemical cycles, particularly in dynamic environments like estuaries, where halotolerant microbes thrive in response to variable salinity...
    Density and Archimedes' Principle01:05

    Density and Archimedes' Principle

    When a lump of clay is dropped into water, it sinks. But if the same lump of clay is molded into the shape of a boat, it starts to float. Because of its shape, the clay boat displaces more water than the lump and experiences a greater buoyant force, even though its mass is the same. The same holds true for steel ships. The average density of an object majorly determines if the object will float. If an object's average density is less than that of the surrounding fluid, it will float. The reason...
    Deep Sea Microbial Ecology01:18

    Deep Sea Microbial Ecology

    The deep ocean and its underlying sediments represent vast, largely unexplored microbial habitats that extend far beyond the sunlit photic zone. The photic (euphotic) zone typically spans the upper ~100–200 meters of pelagic waters in the open ocean, but its depth varies geographically and seasonally, where sufficient light supports photosynthetic life. Below this lies the deep sea, spanning roughly 1000–6000 meters (bathypelagic to abyssal zones), with deeper hadal trenches extending beyond...
    Fluid Pressure over Flat Plate of Constant Width01:05

    Fluid Pressure over Flat Plate of Constant Width

    When a body is submerged in water, it experiences fluid pressure acting normal on its surface and distributed over its area. For better design structures, it is crucial to determine the magnitude and location of the resultant force acting on the surface. In the case of a rectangular plate of constant width submerged in water, the pressure increases with depth, resulting in a linearly varying trapezoidal pressure distribution from the upper to the lower edge of the plate.
    The resultant force...
    Buoyancy01:12

    Buoyancy

    When an object is placed in a fluid, it either floats or sinks. All objects in a fluid experience a buoyant force. For example, a metal ball sinks, while a rubber ball floats. Similarly, a submarine can sink and float by adjusting its buoyancy.  The concept of buoyancy raises several interesting questions. For instance, where does this buoyant force come from? How much buoyant force is required to make an object sink or float? Do objects that sink get any support at all from the fluid? 
    To get...