Related Experiment Video

Updated: Jun 16, 2026

Direct Comparison of Hyperspectral Stimulated Raman Scattering and Coherent Anti-Stokes Raman Scattering Microscopy for Chemical Imaging
09:46

Direct Comparison of Hyperspectral Stimulated Raman Scattering and Coherent Anti-Stokes Raman Scattering Microscopy for Chemical Imaging

Published on: April 28, 2022

Theoretical comparison of singly multiplexed hadamard transform spectrometers and scanning spectrometers

N M Larson, R Crosmun, Y Talmi

    Applied Optics
    |February 6, 2010
    PubMed

    More Related Videos

    Multiplex Chemical Imaging Based on Broadband Stimulated Raman Scattering Microscopy09:57

    Multiplex Chemical Imaging Based on Broadband Stimulated Raman Scattering Microscopy

    Published on: July 25, 2022

    A Multimodal Wide-Field Fourier-Transform Raman Microscope06:48

    A Multimodal Wide-Field Fourier-Transform Raman Microscope

    Published on: December 30, 2025

    Related Concept Videos

    Tandem Mass Spectrometry01:21

    Tandem Mass Spectrometry

    Tandem mass spectrometry is a technique that uses multiple mass analyzers in series to obtain a higher selectivity and reduce chemical noise during analyte detection. Instruments with multiple analyzers separated by an interaction cell enable secondary fragmentation and selected study of the fragment ions.Secondary fragmentations occur in the interaction cell and can be induced by various factors. Fragmentation induced by collision with inert gases, such as N2, Ar, He, etc., is called...
    Inductively Coupled Plasma Atomic Emission Spectroscopy: Instrumentation01:26

    Inductively Coupled Plasma Atomic Emission Spectroscopy: Instrumentation

    Inductively coupled plasma (ICP) is the common plasma source used in atomic emission spectroscopy (AES), a technique that detects and analyzes various elements in a sample. This method is often called inductively coupled plasma atomic emission spectroscopy (ICP-AES).
    There are three main types of inductively coupled plasma atomic emission spectroscopy  (ICP-AES) instruments: sequential, simultaneous multichannel, and Fourier transform instruments, with the latter being less commonly used.
    IR Spectrometers01:25

    IR Spectrometers

    There are two main infrared (IR) spectrophotometers: dispersive IR spectrometers and Fourier transform infrared (FTIR) spectrometers. In a dispersive IR spectrometer, a beam of infrared radiation produced by a hot wire is divided into two parallel equal-intensity beams using mirrors. One beam passes through the sample, while another is a reference beam. The beams then move through the monochromator, which separates the radiations into a continuous spectrum of different frequencies. The...
    Raman Spectroscopy Instrumentation: Overview01:26

    Raman Spectroscopy Instrumentation: Overview

    A conventional Raman spectrophotometer includes a laser source, a sample holding system, a wavelength selector, and a detector.
    The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...
    2D NMR: Heteronuclear Single-Quantum Correlation Spectroscopy (HSQC)01:19

    2D NMR: Heteronuclear Single-Quantum Correlation Spectroscopy (HSQC)

    Heteronuclear single-quantum correlation spectroscopy (HSQC) is a 2D NMR technique that reveals one-bond correlations between hydrogen and a heteronucleus. The HSQC experiment is similar to the heteronuclear correlation experiment (HETCOR) but is more sensitive. In the HSQC spectrum, the proton chemical shift is plotted on the horizontal F2 axis, while the 13C chemical shift is plotted on the vertical F1 axis. The corresponding proton and 13C spectra are also shown. The HSQC contour plot does...
    UV–Vis Spectrometers01:14

    UV–Vis Spectrometers

    The absorbance of UV and visible (UV–visible) radiations is measured using a UV–visible spectrophotometer. Deuterium lamps, which emit UV radiation, and tungsten lamps, which produce radiation in the visible region, are used as light sources in UV–visible spectrophotometers. A monochromator or prism is used for diffraction grating, i.e., to split the incoming radiation into different wavelengths. A system of slits is used to focus the desired wavelength on the sample cell. Samples for...