Related Experiment Video
Updated: Jun 16, 2026

Evaluation of an Exclusive Spur Dike U-Turn Design with Radar-Collected Data and Simulation
Published on: February 1, 2020
Evaluating the role of weaving section characteristics and traffic on crashes in weaving areas
Srinivas S Pulugurtha1, Jaimin Bhatt
1Civil & Environmental Engineering, Center for Transportation Policy Studies, The University of North Carolina at Charlotte, Charlotte, NC 28223-0001, USA. sspulugurtha@uncc.edu
Objective:
The likelihood of being involved in a crash on a freeway, in general, is greater on weaving sections than on basic freeway sections and in ramp influence areas. This is due to possible crossing of entry and/or exit traffic over a short distance while traveling in the same direction without the aid of traffic control devices resulting in potential conflicting situations and crashes. This article focuses on evaluating the role of weaving section characteristics (configuration type, length and the number of required lane changes by weaving traffic) and traffic variables (entry volume, exit volume, and non-weaving volume) on crashes in weaving areas.
Methods:
Data collected for 25 weaving sections in the Las Vegas metropolitan area are used to study the relationship between crashes and weaving section characteristics and traffic variables. The relationship between (1) crashes by selected collision types and contributing factors and (2) weaving section characteristics and traffic variables are also examined. Descriptive and statistical analysis techniques were used.
Results:
The number of crashes tends to decrease with increase in length of weaving section. Increase in entry volume increases crashes due to improper lane change and ran off roadway crashes. On the other hand, increase in exit volume increases rear-end crashes, crashes due to following too closely, and crashes due to inattentive driving. Non-weaving volume, in general, also appears to play a prominent role in explaining most crash types and contributing factors on weaving sections.
Conclusions:
Type "A" weaving section tends to be relatively safer when compared to other weaving configuration section types. Retrofitting weaving sections with short lengths or designing sections with longer lengths, in addition to increased use of in-vehicle warning systems, may reduce crashes and improve safety. Ramp metering, enforcement, changeable message signs (speed signs), and capacity improvements are other solutions for consideration.
Related Concept Videos
Elastic Collisions: Case Study
Stress: General Loading Conditions
The shearing force, possessing potential directionality within the plane of the section, is simplified into two component forces running parallel to the x and y axes.
Design Consideration
The factor of safety is another key aspect...
Unsymmetric Loading of Thin-Walled Members
The concept of the shear center is crucial in countering the...
Factors Affecting Creep
Further, the water/cement ratio is critical, as a lower ratio increases concrete strength, thus reducing creep. The strength of the...
Factors Affecting Workability

