Related Experiment Video
Updated: Jun 16, 2026

Micropatterned Magneto-Rheological Elastomers to Drive Changes in Cardiomyocyte Alignment
Published on: June 10, 2025
Passive stiffness of myocardium from congenital heart disease and implications for diastole
Rajiv R Chaturvedi1, Todd Herron, Robert Simmons
1Division of Cardiology, Hospital for Sick Children, 555 University Ave, Toronto M5G 1X8, Canada. rajiv.chaturvedi@sickkids.ca
Background:
In ventricular dilatation or hypertrophy, an elevated end-diastolic pressure is often assumed to be secondary to increased myocardial stiffness, but stiffness is rarely measured in vivo because of difficulty. We measured in vitro passive stiffness of volume- or pressure-overloaded myocardium mainly from congenital heart disease.
Methods And Results:
Endocardial ventricular biopsies were obtained at open heart surgery (n=61; pressure overload, 36; volume-overload, 19; dilated cardiomyopathy, 4; normal donors, 2). In vitro passive force-extension curves and the stiffness modulus were measured in skinned tissue: muscle strips, strips with myofilaments extracted (mainly extracellular matrix), and myocytes. Collagen content (n=38) and titin isoforms (n=16) were determined. End-diastolic pressure was measured at cardiac catheterization (n=14). Pressure-overloaded tissue (strips, extracellular matrix, myocytes) had a 2.6- to 7.0-fold greater force and stiffness modulus than volume-overloaded tissue. Myocyte force and stiffness modulus at short stretches (0.05 resting length, L(0)) was pressure-overloaded >normal approximately volume-overloaded>dilated cardiomyopathy. Titin N2B:N2BA isoform ratio varied little between conditions. The extracellular matrix contributed more to force at 0.05 L(0) in pressure-overloaded (35.1%) and volume-overloaded (17.4%) strips than normal myocardium. Stiffness modulus increased with collagen content in pressure-overloaded but not volume-overloaded strips. In vitro stiffness modulus at 0.05 L(0) was a good predictor of in vivo end-diastolic pressure for pressure-overloaded but not volume-overloaded ventricles and estimated normal end-diastolic pressure as 5 to 7 mm Hg.
Conclusions:
An elevated end-diastolic pressure in pressure-overloaded, but not volume-overloaded, ventricles was related to increased myocardial stiffness. The greater stiffness of pressure-overloaded compared with volume-overloaded myocardium was due to the higher stiffness of both the extracellular matrix and myocytes. The transition from normal to very-low stiffness myocytes may mark irreversible dilatation.
More Related Videos
11:04Quantification of Global Diastolic Function by Kinematic Modeling-based Analysis of Transmitral Flow via the Parametrized Diastolic Filling Formalism
Published on: September 1, 2014
10:21Scanning Electron Microscopy of Macerated Tissue to Visualize the Extracellular Matrix
Published on: June 14, 2016
Related Concept Videos
Mitral Stenosis I: Introduction
Cardiomyopathy IV: Restrictive Cardiomyopathy
Cardiomyopathy III: Hypertrophic Cardiomyopathy
Imbalances in Cardiac Output
CHF can occur due to the failure of either side of the heart. Left-side failure leads to pulmonary congestion—the right side continues to send blood...
Cardiomyopathy II: Dilated Cardiomyopathy
Mitral Stenosis II: Clinical features and Diagnostic Tests