Related Experiment Videos
Enamel-resin bond durability of self-etch and etch & rinse adhesives
Raquel Osorio1, Francesca Monticelli, Mario A G Moreira
1Department of Dental Materials, Dental School, University of Granada, Colegio Máximo, Campus de Cartuja s/n 18017 Granada, Spain.
Purpose:
To evaluate the degradation of resin-enamel interfaces bonded with different adhesive systems.
Methods:
Flat enamel surfaces were ground buccally on bovine incisors. Two etch & rinse self-priming adhesives (Single Bond, Prime & Bond NT), three two-step self-etch adhesives (Clearfil SE Bond, Resulcin Aquaprime, NRC/Prime & Bond NT) and two all-in-one adhesives (Etch & Prime 3.0, Adper Prompt-L-Pop) were used for bonding. A hybrid resin composite (Tetric Ceram) was selected for coronal build-up. Bonded specimens were stored in water at 37 degrees C for 24 hours, 6 months and 1 year, respectively, and then sectioned into 1 mm2 beams. Each microtensile stick was loaded in tension until failure (crosshead speed: 0.5 mm/minute). Bond strength data were analyzed with two-way ANOVA and Student Newman Keuls tests (P < 0.05). Etching patterns resulting from phosphoric acid etching and self-etch adhesives application on ground enamel were analyzed under SEM.
Results:
All adhesives attained similar bond strengths after 24 hours. All-in-one adhesives and Resulcin Aqua Prime recorded a significant reduction in bond strengths after 6 months and 1 year of water aging.
