Identifying sources of lead exposure for children, with lead concentrations and isotope ratios

Despite a dramatic decrease in children's blood lead levels (BLL), lead exposure remains a public health concern because increasing evidence shows effects at very low doses. Lowering BLL still further requires the identification of lead sources and, therefore, new tools to investigate and thus prevent exposure. We describe a procedure that uses both lead concentrations and isotope ratios (IRs) to identify sources of overexposure in homes. Water, dust, and paint chips were sampled from the homes of 21 children with elevated BLL from Aubervilliers (Paris metropolitan area). Lead concentrations of concern were calculated from reverse physiologically based pharmacokinetic modeling for water and dust. Isotope ratio matching of blood and environmental samples (with a lead content above the concentration of concern) was performed by computation of the distance between their IRs. When the IR of the source did not match that of the blood, the source was eliminated as a source of lead intoxication. The number of sources eliminated (per child) due to lead concentration ranged from 14% to 86% (mean 66%) for dust, and 100% for water samples. The number of remaining potential sources eliminated by IR interpretation varied from 0% to 100% for both dust and paint chips (mean 63% and 58%, respectively). IRs made it possible to eliminate at least one source in 20 of 21 cases and identified a single source in 11 of 21. The number of dust and paint sources not eliminated by concentration or IR varied from 8% to 45% (median 18%). The pilot study supports the usefulness of these procedures and the added value of IRs for identifying sources of lead poisoning. However, systematic use should be supported by cost-effectiveness analysis on a larger and more representative population of elevated BLL.