Developments in bile acid kinetic measurements using (13)C and (2)H: 10(5) times improved sensitivity during the last...

Bile acid kinetics involve the measurement of pool sizes and turnover rates of individual bile acids. The technique is based on isotope dilution and was first described in the 1950s using radioactive (14)C-labelled cholic acid (CA). It took until the 1970s before stable isotopes were introduced for this purpose ((13)C, (2)H) and isotope analysis methods were developed for CA and chenodeoxycholic acid (CDCA) applying gas chromatography/electron impact mass spectrometry. Until the 1980s, the isotope enrichment measurements were performed in bile samples aspirated from the duodenum. Thereafter, methodology became available allowing measurements to be performed in blood requiring at least 2 ml serum samples. Simultaneous measurement of kinetics of metabolically dependent CA and deoxycholic acid using (13)C and (2)H labels was introduced. Until the 1990s, this technique was only possible in adult humans due to the large sample sizes. Introduction of pentafluorobenzyl bromide derivatisation and electron capture negative ion mass spectrometry (GC/ECN-MS) reduced the sample volume to 50 microl serum. This allowed isotope abundance measurement of CA in rats and in mice. However, repetitive collection of 100 microl blood samples in mice is too invasive (collection via the orbita) and exhaustive. Therefore, the method development is now focussing on enhanced sensitivity and reduction of blank effects originating from the sample preparation. The final goal is to determine CA isotope enrichments in 20 microl mouse blood obtained from the tail vein. This paper shows the feasibility of reaching this goal.