Related Experiment Video

Updated: Jun 15, 2026

Fabrication of a Low-Cost, Fiber-Coupled, and Air-Spaced Fabry-Pérot Etalon
07:22

Fabrication of a Low-Cost, Fiber-Coupled, and Air-Spaced Fabry-Pérot Etalon

Published on: February 3, 2023

Analytical description of a Fabry-Perot spectrometer. 5: Optimization for minimum uncertainties in the determination

G Hernandez

    Applied Optics
    |March 11, 2010
    PubMed

    More Related Videos

    High Speed Sub-GHz Spectrometer for Brillouin Scattering Analysis13:31

    High Speed Sub-GHz Spectrometer for Brillouin Scattering Analysis

    Published on: December 22, 2015

    Implementation of a Reference Interferometer for Nanodetection16:11

    Implementation of a Reference Interferometer for Nanodetection

    Published on: April 26, 2014

    Related Concept Videos

    UV–Vis Spectroscopy: Woodward–Fieser Rules01:29

    UV–Vis Spectroscopy: Woodward–Fieser Rules

    UV–Visible absorption spectra of conjugated dienes arise from the lowest energy π → π* transitions. The light-absorbing part of the molecule is called the chromophore, and the substituents directly attached to the chromophore are called auxochromes. A strong correlation exists between the absorption maxima, λmax, and the structure of a conjugated π system. The Woodward–Fieser rules predict the value of λmax for a given structure by adding the contributions...
    NMR Spectrometers: Resolution and Error Correction01:14

    NMR Spectrometers: Resolution and Error Correction

    When magnetic nuclei in a sample achieve resonance and undergo relaxation, the signal detected in NMR is an approximately exponential free induction decay. Fourier transform of an exponential decay yields a Lorentzian peak in the frequency domain. Lorentzian peaks in an NMR spectrum are defined by their amplitude, full width at half maximum, and position, where the peak width is governed by the spin-spin relaxation time alone. In real experiments, however, the applied magnetic field is rendered...
    IR Spectroscopy: Hooke's Law Approximation of Molecular Vibration01:16

    IR Spectroscopy: Hooke's Law Approximation of Molecular Vibration

    A covalently bonded heteronuclear diatomic molecule can be modeled as two vibrating masses connected by a spring. The vibrational frequency of the bond can be expressed using an equation derived from Hooke's law, which describes how the force applied to stretch or compress a spring is proportional to the displacement of the spring. In this case, the atoms behave like masses, and the bond acts like a spring.
    According to Hooke's law, the vibrational frequency is directly proportional to the...
    ¹H NMR: Interpreting Distorted and Overlapping Signals01:02

    ¹H NMR: Interpreting Distorted and Overlapping Signals

    Spin systems where the difference in chemical shifts of the coupled nuclei is greater than ten times J are called first-order spin systems. These nuclei are weakly coupled, and their chemical shifts and coupling constant can generally be estimated from the well-separated signals in the spectrum.
    As Δν decreases and the signals move closer, the doublets appear increasingly distorted. The intensities of the inner lines increase at the cost of those of the outer lines as the signals are slanted or...
    Spectrophotometry: Introduction01:16

    Spectrophotometry: Introduction

    Spectrophotometry is the quantitative measurement of the absorption, reflection, diffraction, or transmission of electromagnetic radiation through a material as a function of the intensity and wavelength of the radiation. A spectrophotometer is a device used to measure the change in the radiation intensity caused by its interaction with the material.
    The essential components of a spectrophotometer include a source of electromagnetic radiation, a slot for placing a material to be analyzed, and a...
    Doppler Effect - II01:05

    Doppler Effect - II

    The Doppler effect has several practical, real-world applications. For instance, meteorologists use Doppler radars to interpret weather events based on the Doppler effect. Typically, a transmitter emits radio waves at a specific frequency toward the sky from a weather station. The radio waves bounce off the clouds and precipitation and travel back to the weather station. The radio frequency of the waves reflected back to the station appears to decrease if the clouds or precipitation are moving...