Related Experiment Video
Updated: Jun 15, 2026

A Protein Microarray Assay for Serological Determination of Antigen-specific Antibody Responses Following Clostridium difficile Infection
Published on: June 15, 2018
Tolerability of a new 10% liquid immunoglobulin for intravenous use, Privigen, at different infusion rates
John W Sleasman1, Carla M Duff, Theresa Dunaway
1Department of Pediatrics, University of South Florida, St. Petersburg, FL, USA. jsleasma@health.usf.edu
Purpose:
The tolerability of L-proline-stabilized Privigen, a new 10% liquid immunoglobulin for intravenous administration, was assessed at high infusion rates in a Phase III, open-label, single-arm, multicenter study in 45 patients with primary immune deficiencies.
Patients And Methods:
Maximum infusion rates were not assigned prospectively. For analysis, patients were grouped according to maximum infusion rate in a low infusion rate group (8 mg/kg/min) and high infusion rate group (12 mg/kg/min).
Results:
Twenty-three patients, selected at the investigators' discretion for the high infusion rate group based on their good tolerability, tolerated Privigen at 12 mg/kg/min with no increase in temporally associated adverse events (AEs) above the level they had experienced at 8 mg/kg/min. The proportion of infusions with temporally associated AEs in these patients was 0.079 [97.5% confidence interval (CI) 0.114] compared to 0.211 (97.5% CI 0.267) in the low infusion rate group. The most frequent AE was headache. Thus, selected patients tolerate Privigen at high infusion rates.
Related Concept Videos
Drug Accumulation During Multiple Dosing: Intermittent IV Infusions
One-Compartment Model: IV Infusion
The one-compartment model for IV infusion uses mathematical equations to describe the rate of change in drug quantity in the body. At steady-state or infusion equilibrium, the drug input...
IV Infusion to Oral Dosing: Conversion Methods
Routes of Drug Administration: Parenteral
The intravenous route (IV) of drug administration can be further categorized into two types. The bolus injection administers the entire dose rapidly, while an intravenous infusion slowly delivers smaller doses steadily.
The IV route is often...
Determination of Multiple Dosing Parameters: Steady-State, Minimum and Maximum Concentrations
Dosage Regimens: Partial Pharmacokinetic Parameters

