Production of surfactin and fengycin by Bacillus subtilis in a bubbleless membrane bioreactor
Related Experiment Video
Updated: Jun 15, 2026

Enhanced Oil Recovery using a Combination of Biosurfactants
Published on: June 3, 2022
François Coutte1, Didier Lecouturier, Saliha Ait Yahia
1ProBioGEM, Laboratoire de Procédés Biologiques, Génie Enzymatique et Microbien, Polytech'Lille, Univ Lille Nord de France, USTL, Avenue du Professeur Langevin, F-59655, Villeneuve d'Ascq Cedex, France.
Abstract:
Surfactin and fengycin are lipopeptide biosurfactants produced by Bacillus subtilis. This work describes for the first time the use of bubbleless bioreactors for the production of these lipopeptides by B. subtilis ATCC 21332 with aeration by a hollow fiber membrane air-liquid contactor to prevent foam formation. Three different configurations were tested: external aeration module made from either polyethersulfone (reactor BB1) or polypropylene (reactor BB2) and a submerged module in polypropylene (reactor BB3). Bacterial growth, glucose consumption, lipopeptide production, and oxygen uptake rate were monitored during the culture in the bioreactors. For all the tested membranes, the bioreactors were of satisfactory bacterial growth and lipopeptide production. In the three configurations, surfactin production related to the culture volume was in the same range: 242, 230, and 188 mg l(-1) for BB1, BB2, and BB3, respectively. Interestingly, high differences were observed for fengycin production: 47 mg l(-1) for BB1, 207 mg l(-1) for BB2, and 393 mg l(-1) for BB3. A significant proportion of surfactin was adsorbed on the membranes and reduced the volumetric oxygen mass transfer coefficient. The degree of adsorption depended on both the material and the structure of the membrane and was higher with the submerged polypropylene membrane.
Related Concept Videos
Production of Biopesticides
Production of Antibiotics
Bioreactor Design and Operational System
Bioreactor Controls-II

