Related Experiment Video

Updated: Jun 14, 2026

Fabrication and Characterization of High-Q Silicon Nitride Membrane Resonators
09:46

Fabrication and Characterization of High-Q Silicon Nitride Membrane Resonators

Published on: August 8, 2025

Mode properties of a strip confocal unstable resonator with saturable gain

M J Smith

    Applied Optics
    |March 24, 2010
    PubMed

    More Related Videos

    High-speed Continuous-wave Stimulated Brillouin Scattering Spectrometer for Material Analysis07:55

    High-speed Continuous-wave Stimulated Brillouin Scattering Spectrometer for Material Analysis

    Published on: September 22, 2017

    Microwave Photonics Systems Based on Whispering-gallery-mode Resonators12:18

    Microwave Photonics Systems Based on Whispering-gallery-mode Resonators

    Published on: August 5, 2013

    Related Concept Videos

    Parallel Resonance01:23

    Parallel Resonance

    The parallel RLC circuit is an arrangement where the resistor (R), inductor (L), and capacitor (C) are all connected to the same nodes and, as a result, share the same voltage across them. The parallel RLC circuit is analyzed in terms of admittance (Y), which reflects the ease with which current can flow. The admittance is given by:
    Oscillations In An LC Circuit01:30

    Oscillations In An LC Circuit

    An idealized LC circuit of zero resistance can oscillate without any source of emf by shifting the energy stored in the circuit between the electric and magnetic fields. In such an LC circuit, if the capacitor contains a charge q before the switch is closed, then all the energy of the circuit is initially stored in the electric field of the capacitor. This energy is given by
    RLC Circuit as a Damped Oscillator01:30

    RLC Circuit as a Damped Oscillator

    An RLC circuit combines a resistor, inductor, and capacitor, connected in a series or parallel combination.
    Consider a series RLC circuit. Here, the presence of resistance in the circuit leads to energy loss due to joule heating in the resistance. Therefore, the total electromagnetic energy in the circuit is no longer constant and decreases with time. Since the magnitude of charge, current, and potential difference continuously decreases, their oscillations are said to be damped. This is...
    Design Example: Underdamped Parallel RLC Circuit01:17

    Design Example: Underdamped Parallel RLC Circuit

    Consider designing an oscillator circuit, a crucial component in various electronic devices and systems. The objective is to create an oscillator circuit with specific characteristics: a damped natural frequency of 4 kHz and a damping factor of 4 radians per second. To accomplish this, a parallel RLC circuit is employed, known for its ability to sustain oscillations at a resonant frequency. In this case, the damping factor is pivotal in achieving the desired performance.
    Starting with a fixed...
    Characteristics of Series Resonant Circuit01:24

    Characteristics of Series Resonant Circuit

    Series resonance occurs in a circuit containing inductive (L), capacitive (C), and resistive (R) elements connected sequentially. At the resonance frequency, the inductive and capacitive reactances are equal in magnitude but opposite in sign, effectively canceling each other. This causes the circuit's impedance is minimal, primarily determined by the resistance R. The resonant frequency of an RLC circuit is defined as:
    Small-Signal Analysis of MOSFET Amplifiers01:23

    Small-Signal Analysis of MOSFET Amplifiers

    In small-signal analysis, a MOSFET transistor amplifier acts as a linear amplifier when operating in its saturation region. The gate-to-source voltage (VGS) of the MOSFET is the sum of the DC biasing voltage and the small time-varying input signal. This combination sets up the operating point and modulates the drain current (ID) that flows from the drain to the source. When a small AC signal is superimposed on the DC bias voltage at the gate, the instantaneous drain current comprises three...