Related Experiment Video

Updated: Jun 14, 2026

Temperature-Controlled Assembly and Characterization of a Droplet Interface Bilayer
10:11

Temperature-Controlled Assembly and Characterization of a Droplet Interface Bilayer

Published on: April 19, 2021

Time-temperature integrator based on the dewetting of polyisobutylene thin films

Annalisa Calò1, Pablo Stoliar, Francesco Cino Matacotta

  • 1CNR-ISMN, Via P. Gobetti 101, 40121 Bologna, Italy.

Langmuir : the ACS Journal of Surfaces and Colloids
|March 26, 2010
PubMed

More Related Videos

Synthesis of Terpolymers at Mild Temperatures Using Dynamic Sulfur Bonds in Poly(S-Divinylbenzene)09:16

Synthesis of Terpolymers at Mild Temperatures Using Dynamic Sulfur Bonds in Poly(S-Divinylbenzene)

Published on: May 20, 2019

Methods for the Self-integration of Megamolecular Biopolymers on the Drying Air-LC Interface07:06

Methods for the Self-integration of Megamolecular Biopolymers on the Drying Air-LC Interface

Published on: April 7, 2017

Related Concept Videos

Types of Step-Growth Polymers: Polyesters01:20

Types of Step-Growth Polymers: Polyesters

The introduction of polyesters has brought major development to the textile industry. The wrinkle-free behavior of polyester blends has eliminated the need for starching and ironing clothes.
Polyesters are commonly prepared from terephthalic acid and ethylene glycol; the crude product is known as poly(ethylene terephthalate) or PET. However, polyesters are synthesized industrially by transesterification of dimethyl terephthalate with ethylene glycol at 150 °C. The two reactants and the polymer...
Temperature Dependent Deformation01:12

Temperature Dependent Deformation

In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added together...