Related Concept Videos

Latitudes and Departures01:27

Latitudes and Departures

Latitudes and departures are essential concepts in surveying, providing a systematic way to analyze the projections of traverse lines. These projections allow surveyors to interpret a line's north-south and east-west components, which are crucial for precisely calculating areas, bearings, and lengths. Latitude is the north-south projection of a line, calculated as the product of the line's length and the cosine of its bearing. Departure, conversely, is the east-west projection obtained by...
Jaundice01:25

Jaundice

Jaundice, or icterus, is the yellow discoloration of the skin, sclerae, and mucous membranes. It happens when plasma bilirubin levels rise above 2.5-3 mg/dL, leading to bilirubin deposition in tissue.Bilirubin is a byproduct of hemoglobin degradation. In macrophages, hemoglobin breaks down into globin and heme. Globin is converted into amino acids, while heme is turned into biliverdin by heme oxygenase, which is then reduced to unconjugated bilirubin by biliverdin reductase.Unconjugated...
Rabies01:28

Rabies

Rabies is a lethal zoonotic disease caused by a single-stranded, negative-sense RNA virus of the Lyssavirus genus, within the family Rhabdoviridae. Its primary mode of transmission to humans is through bites or saliva-contaminated scratches from infected mammals such as dogs, bats, raccoons, or foxes. Transmission can also occur if infectious saliva contacts abraded skin or intact mucous membranes, including the conjunctiva.Viral Entry and Early ReplicationOnce introduced at the bite or scratch...
Masonry in Cold and Hot Weather Conditions01:21

Masonry in Cold and Hot Weather Conditions

In cold weather, masonry construction requires specific precautions to ensure mortar does not freeze before curing, as this can significantly weaken its strength and watertightness. Mortar temperature should be maintained between 60°F and 80°F to support proper hydration and curing. Below 40°F, mortar water must be heated, but should not exceed 120°F as high temperatures can reduce mortar's compressive and bond strength.
Other key practices include keeping masonry units and sand dry and...