Difference in the wind speeds required for initiation versus continuation of sand transport on mars: implications for

Jasper F Kok1

  • 1Department of Atmospheric, Oceanic, and Space Sciences, University of Michigan, Ann Arbor, Michigan 48109, USA. jfkok@umich.edu

Related Concept Videos

Torque Free Motion01:15

Torque Free Motion

The torque-free motion refers to the movement of a rigid body in space when no external torques are acting upon it. This type of motion can be observed in environments where there are no external forces or frictions, like in outer space. For example, a rotation of Mars in space is a torque-free motion. Mars is an axisymmetric object, meaning it has an axis of symmetry along which it rotates, designated as the z-axis. The rotating frame of reference is defined such that the center of mass of...
Design Example: Calculating Safe Diameter for Wind-Exposed Disc01:17

Design Example: Calculating Safe Diameter for Wind-Exposed Disc

Assessing safety in wind-exposed installations is crucial to preventing potential failures. This example explores the calculation and design adjustments needed to mount a circular disc on a building facade, where wind forces are a primary concern. A 4-meter diameter disc was initially designed as an aesthetic feature facing winds at a velocity of 25 meters per second, with an air density of 1.25 kilograms per cubic meter. Given these conditions, the drag force on the disc was determined using...
Vectors in 2D: Problem Solving01:29

Vectors in 2D: Problem Solving

A plane traveling due north at 180 km/h in still air was found to be 80 km off-course after 30 minutes, deviating approximately 5 degrees east of north. This deviation means the influence of a crosswind alters the plane’s intended trajectory. The actual ground path formed a diagonal, suggesting that the aircraft’s effective ground speed was reduced to 160 km/h and directed slightly to the east due to the wind.By analyzing the displacement from the intended path, the velocity contributed by the...
Impact: Problem Solving01:26

Impact: Problem Solving

In an experiment conducted during a Mars mission, a rover propels a projectile with an initial velocity, and the projectile rebounds after colliding with the Martian surface. To ascertain the maximum height attained by the projectile after this collision, the known restitution coefficient and acceleration due to gravity are employed.
By designating the launch point as the origin and utilizing kinematic equations, the vertical component of the projectile's velocity at the point of impact is...
Design Example: Aggregate Gradation01:24

Design Example: Aggregate Gradation

The right type and quality of aggregates are crucial for concrete as they significantly influence its properties, mix proportions, and cost-effectiveness. If different sources are available for sand, the commonly used fine aggregate in concrete, the selection of sand is primarily based on its gradation.
The grading, or particle-size distribution, of sand is determined using sieve analysis, with standard sizes ranging from 150 μm to 10 mm (ASTM No. 100 sieve to 3⁄8 in. sieve). Sand is sampled...
Acceleration due to Gravity on Other Planets01:24

Acceleration due to Gravity on Other Planets

The gravitational acceleration of an object near the Earth's surface is called the acceleration due to gravity. It can be measured by conducting simple experiments on Earth. However, such an experiment is impossible to conduct on the surface of other planets.
Astronomical observations are thus used to measure the acceleration due to gravity on other planets. This can be determined by observing the effect of a planet's gravity on objects close to it. The crucial factor that helps in this...