Related Experiment Video
Updated: Jun 13, 2026

Capturing Flow-weighted Water and Suspended Particulates from Agricultural Canals During Drainage Events
Published on: November 7, 2017
Removal patterns of particulate and dissolved forms of pollutants in a stormwater wetland
Qitao Yi1, Jianghua Yu, Youngchul Kim
1Department of Environmental Science and Engineering, Anhui University of Science and Technology, 232-001, China.
Abstract:
A 0.23-ha pilot wetland was constructed to examine its effectiveness for the control of nonpoint source pollution (NPS) from a 7.42-ha agricultural watershed in Korea. This research emphasised the removal patterns of particulate and dissolved forms of pollutants on both dry (base flow) and wet days (storm flow). The hydraulic loading rates were high on rainy days, with an average value of 0.78 m/day, but around 0.08 m/day on dry days. Particulate forms of pollutants, such as TSS, COD and TP, were removed to a greater extent on wet days due to sedimentation. On wet days, the incoming concentrations of NH(4)-N and soluble reactive phosphorus (SRP) were higher than during dry days, and can be partly retained via filtration and adsorption as they go through the wetland. The retention of TP and TSS on dry days could be affected by short antecedent dry days (ADDs), which will cause frequent hydraulic fluctuations in the wetland. Nitrogen removal is not influenced by this condition, with an average retention of around 20% on dry days, higher than the 6% removal on wet days.
Related Concept Videos
Microbial Wastewater Treatment
Conservation of Mass in Moving, Nondeforming Control Volume
In the context of a detention basin, the conservation of mass states that the total mass of water entering the basin must equal the mass leaving the basin plus any accumulation of...
Biological Treatment of Effluent and Waste Water
Coagulation
Voltammetry: Stripping Methods
Anodic Stripping Voltammetry (ASV)
ASV is used to determine metals and metalloids at trace levels. It involves two steps: deposition and stripping. First, a negative potential is applied to the...
Precipitate Formation and Particle Size Control
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...

