Related Experiment Video
Updated: Jun 13, 2026

Introducing an Angle Adjustable Cutting Box for Analyzing Slice Shear Force in Meat
Published on: April 26, 2013
Efficacy of performing Warner-Bratzler and slice shear force on the same beef steak following rapid cooking
C L Lorenzen1, C R Calkins, M D Green
1Division of Animal Sciences, University of Missouri, 112C Animal Science Research Center, Columbia, MO 65211, USA. LorenzenC@missouri.edu
Abstract:
The ability to perform Warner-Bratzler and slice shear force on the same beef top loin steak was investigated. Three, 2.54-cm steaks from top loins (n=99) were allotted to either Warner-Bratzler only (WBS), slice shear force only (SSF), or Warner-Bratzler and slice shear force (WBS/SSF). Steaks were thawed at 2 degrees C for 48h prior to cooking. Steaks were cooked to 71 degrees C using a conveyor convection oven and allowed to cool at room temperature for a minimum of 4h. Steaks allotted to WBS used six 1.27-cm cores and steaks allotted for WBS/SSF used four cores. Steaks allotted to SSF and WBS/SSF used one, 1 cm x 5 cm slice. Correlations among WBS and SSF for all steaks ranged from 0.49 to 0.69 (P<0.0001). When correlations were generated for steak location within the top loin, the relationships among WBS and SSF performed in the same steak ranged from 0.53 to 0.70 (P<0.05). These results indicate that it may be feasible to conduct WBS and SSF on the same top loin steak, and that the steak taken 2.54 cm from the 13th rib is the optimal location for this combination of procedures.
Related Concept Videos
Mechanical Characteristics of Steel
The tension test is fundamental for determining tensile strength. In this test, a steel specimen is stretched using a gripping device until it breaks. The data collected during this test are used to...
Shearing Stress
The average shearing stress can be calculated by dividing the shear by the area of the cross-section.

